National Fierce Task Chair User manual

Proper product installation, in accordance with these instructions, is the responsibility of the installing agent.
If you have any questions concerning these instructions, please call National Customer Service 800.482.1717.
Fierce™ Assembly Instruction
Required Tools
5mm Hex Key (Included)
Package Contents Qty.
1
1
1
1
Back assembly
Plastic base
Gas lift cylinder
Seat assembly
Hardware Kit:
-M6X14 hex head bolts
-M6X30 hex head bolts
-M8X30 hex head bolts
Right arm assembly
Left arm assembly
Weight Balance Control
Mechanism
Set of 5 casters
Telephone [phone]
Fax [phone]
www.NationalOfficeFurniture.com
Part # 3216439
Rev, A
Printed in U.S.A
© 2013 Kimball International, Inc.
Product Line
Fierce™ Task Chair
1Place mesh seat assembly upside down on an elevated flat surface.
Position the right and left arm assemblies on the bottom of the
seat as shown in Figure A. Note: To assure proper assembly of
the right and left arms, each arm should angle toward the front of
the seat, not rearward. Using the 5mm hex key wrench, secure each
arm with (3) M6 X 30 hex head bolts as shown in Figure A.
!
Assemble units as described herein only. All screws and bolts
must be tightened securely and checked periodically after
assembly. Failure to assemble or to secure parts properly may
result in assembly failure and personal injury.
Figure B
2
4
6
3
1
1
1
1
Figure A
3
Position control mechanism on bottom side of mesh seat assembly to
match the back 4-hole configuration. Using the 5mm hex key wrench,
secure the control mechanism to the seat assembly using (4) M6 X 14
hex head bolts as shown in Figure B.
Position the mesh back assembly to the corresponding hole
configuration on the back bottom of the control mechanism. Using the
5mm hex key wrench, secure the mesh back assembly with (3) M8 X 30
hex head bolts as shown in Figure C.
Figure C

Proper product installation, in accordance with these instructions, is the responsibility of the installing agent.
If you have any questions concerning these instructions, please call National Customer Service 800.482.1717.
Figure D
Fierce™ Assembly Instruction
Telephone [phone]
Fax [phone]
www.NationalOfficeFurniture.com
Part # 3216439
Rev, A
Printed in U.S.A
© 2013 Kimball International, Inc.
Insert 5 casters into the plastic base as shown in Figure D.
4
Figure E
Orient the gas lift cylinder as shown and insert the larger end of the
cylinder into the hole in the center of the base. Figure E.
5
Carefully position the seat assembly over the gas lift cylinder, aligning the
hole in the seat control with the top, smaller end of the cylinder. Press
the seat assembly onto the cylinder then sit on the seat to completely
mate the components together. While seated, actuate height control lever
and remove weight from chair to adjust chair up to comfortable sitting height
as shown in Figure F.
6
Figure F