National NOF HC Guest Seating User manual

Proper product installation, in accordance with these instructions, is the responsibility of the installing agent.
If you have any questions concerning these instructions, please call National Customer Service 8 .482.1717.
Weli Assembly Instrucon
RecommendTools
• 5/32” Hex Key or
drive
PackageContentsQty.
• 1/4-2 X 3/4” flat 6
head socket cap screw
• 1/4-2 X 5/8” button 4
head socket cap screw
Telephone [phone]
Fax [phone]
www.NationalOfficeFurniture.com
Part # 3 45797
Rev, -
Printed in U.S.A
© 2 13 Kimball International, Inc.
ProductLine
NOF HC Guest Seating
1
Move the add-on unit into position so that the holes in the
seat rails are aligned with the slots in the mounting rails.
Assemble the rails using the (4) 1/4-2 X 5/8” button head
screws into the threaded holes. Ensure that the underside of
the screws is flush and tight to the face of the mounting
rails.
FigureB
2
FigureC
FigureA
With the starter unit secure, an add-on or end unit (shown)
should be located so that the seat rails will slide into the
mating rail on the outside of the chair.
Note: seat panels and foam have been removed for clarity.

Proper product installation, in accordance with these instructions, is the responsibility of the installing agent.
If you have any questions concerning these instructions, please call National Customer Service 8 .482.1717.
FigureD
Weli Assembly Instrucon
Telephone [phone]
Fax [phone]
www.NationalOfficeFurniture.com
Part # 3 45797
Rev, -
Printed in U.S.A
© 2 13 Kimball International, Inc.
3 Attach the plywood back to the starter frame using the (3)
1/4-2 X 3/4” flat head screws. Ensure the holes are
aligned and the screws should seat in the countersinks on
the mounting plate.
FigureE