National Vora User manual

Proper product installation, in accordance with these instructions, is the responsibility of the installing agent.
If you have any questions concerning these instructions, please call National Customer Service 8 .482.1717.
Vora™ Assembly Instrucon
Required Tools
•5mm Hex Key Wrench
(Included)
Package Contents
Qty.
1
1
1
1
4
•Back assembly
•Plastic base
•Gas lift cylinder
•Seat assembly
•Hardware Kit:
Telephone [phone]
Fax [phone]
www.NationalOfficeFurniture.com
Part # 3215490
Rev, -
Printed in U.S.A
© 2 13 Kimball International, Inc.
Product Line
Vora™ Task Chair
1 Place seat assembly upside down on an elevated flat surface. Position swivel
tilt control mechanism on bottom side of seat assembly to match the inside
4-hole configuration. Note: The swivel tilt control adjustment knob is to be
positioned toward the front of the seat. The front of the seat is identified by
the front asset label. Using the 5mm Hex Key Wrench, secure the swivel tilt
control mechanism to the seat assembly using four 5/16-18 x 1" hex head
bolts. Figure A.
Figure B
3
Figure A
2 Position the right and left arm assemblies on the bottom of the seat as shown
in Figure B. Note: To assure proper assembly of the right and left arms, each
arm should angle toward the front of the seat, not rearward. Using the 5mm
hex key wrench, secure each arm with three 5/16-18 x 1 1/4" truss head bolts.
Position the back assembly to the corresponding hole configuration on the
back bottom of the seat assembly. Using the 5mm hex key wrench, secure
the back assembly with four
5/16-18 x 1 1/4" hex head bolts. Figure C.
1
Front of Seat
Front of Seat
•
•
•
•
Right arm assembly
Left arm assembly
Swivel tilt control
mechanism
Set of five casters
1
1
1
•5/16-18 X 1” hex
head bolts
6
•Hex Key Wrench 1
Figure C
•
•
5/16-18 X 1 1/4”
truss head bolts
5/16-18 X 1 1/4”
hex head bolts 4

Proper product installation, in accordance with these instructions, is the responsibility of the installing agent.
If you have any questions concerning these instructions, please call National Customer Service 8 .482.1717.
Figure D
Assembly Instruction
Telephone [phone]
Fax [phone]
www.NationalOfficeFurniture.com
Part # 3215490
Rev, -
Printed in U.S.A
© 2 13 Kimball International, Inc.
4Insert 5 casters into the plastic base as shown in Figure D.
6
Figure E
4
Figure F
Carefully position the seat assembly over the gas lift cylinder,
aligning the hole in the seat control with the top, smaller end
of the cylinder. Press the seat assembly onto the cylinder
then sit on the seat to completely mate the components
together. While seated, actuate height control lever and
remove weight from chair to adjust chair up to comfortable
sitting height. Figure F.
5Orient the gas lift cylinder as shown and insert the larger end of
the cylinder into the hole in the center of the base. Figure E.