National Maneuver Educational Desk Series User manual

Proper product installation, in accordance with these instructions, is the responsibility of the installing agent.
If you have any questions concerning these instructions, please call National Customer Service 8 .482.1717.
Figure1
Assembly Instrucon
RecommendTools
• Tape measure
• T-Square or straight edge
• Channel lock pliers
• Power drill w/ screw bits
• Pencil
Telephone [phone]
Fax [phone]
www.NationalOfficeFurniture.com
Part # 2878788
Rev A
Printed in U.S.A
© 2 17 Kimball International, Inc.
ManeuverEducational
DeskSeries
1
Unpack all the boxes and locate the hardware kits. The kits will be attached to a
streamer that says hardware. The caster stems will need to be pressed into the casters.
See Figure 1, insert the stem into the caster and press together using a pair of channel
lock pliers. The casters for the mobile pedestal will screw into the inserts on the bottom
panel, make sure to place the flat washer provided on the stem like shown in Figure 2.
Place the locking casters towards the open front, front door side or drawer front side.
Place the non-locking casters towards the rear back panel. Next fasten the hex jam nut
and flat washer to the locking caster stems, see Figure 2 below. Now fasten them into
the feet of the metal Y-base.
Figure2

Proper product installation, in accordance with these instructions, is the responsibility of the installing agent.
If you have any questions concerning these instructions, please call National Customer Service 8 .482.1717.
Figure3
Assembly Instrucon
Telephone [phone]
Fax [phone]
www.NationalOfficeFurniture.com
Part # 2878788
Rev A
Printed in U.S.A
© 2 17 Kimball International, Inc.
ManeuverEducational
DeskSeries
2
24 inch deep left handed desk assembly. Place the work surface on a flat area
so that the back side is facing up. Mark a line 34.5mm parallel from the front
edge of the user’s side and on mark a line 23mm parallel from the left side.
Next mark another line 165mm parallel from the front edge of the user’s side
and mark a line 76mm parallel from the right side. Place the mobile pedestal as
shown below and attach using the four supplied #8 X 1.5in black wood screws.
Place the metal Y-base as shown below and attach using the eight supplied #1
X 1in black wood screws. If an optional modesty panel was ordered place as
shown below, see Figure 3. Reverse the marked line placements if a right
handed desk is to be assembled.

Proper product installation, in accordance with these instructions, is the responsibility of the installing agent.
If you have any questions concerning these instructions, please call National Customer Service 8 .482.1717.
Figure4
Assembly Instrucon
Telephone [phone]
Fax [phone]
www.NationalOfficeFurniture.com
Part # 2878788
Rev A
Printed in U.S.A
© 2 17 Kimball International, Inc.
ManeuverEducational
DeskSeries
3 3 inch deep desk assembly. Place the work surface on a flat area so that the back
side is facing up. Mark a line 34.5mm parallel from the front edge of the user’s side
and on mark a line 23mm parallel from the left side. Next mark another line 242mm
parallel from the front edge of the user’s side and mark a line 9 mm parallel from
the right side. Place the mobile pedestal as shown below and attach using the four
supplied #8 X 1.5in black wood screws. Place the metal Y-base as shown below and
attach using the eight supplied #1 X 1in black wood screws. If an optional modesty
panel was ordered place as shown below, see Figure 4. Reverse the marked line
placements if a right handed desk is to be assembled.