Nilfisk-Advance SW900 Instruction Manual

Nilfisk-Advance A/S
Sognevej 25
DK-2605 Brøndby
Denmark
Tel.: [phone]
Fax: [phone]
mail.com@nilfisk-advance.com
www.nilfisk.com
ATTENTION! Do not use the machine before you have read and understood the User Manual.
3. Turn the ignition key to “I” without
pulling the drive control lever.
8. When operating on wet floors, open
the “wet by-pass” port to avoid
damaging the dust filter. Close the
“wet by-pass” port to restore proper
vacuuming.
13. Clean the machine by using a damp
cloth and where needed use a neutral
cleaning product.
2. Adjust the handlebar by using the
lever
7. Activate the filter shaker switch every
10 min.
12. Remove and clean the dust filter as
indicated into the manual.
4. Lower the side broom by pulling the
lever backwards.
9. Release the traction lever, lift the side
broom by and turn off the machine
with the ignition key “0”.
14. Connect the battery charger cable
to the electrical main
5. Activate the traction by pulling the
lever.
10. Remove the hopper by pulling the
handle and drive it to the area of
disposal and empty it and put the
hopper back on the machine
15. Park the machine into dry and
clean storage area.
1. Disconnect the battery charger cable
from the electrical main.
6. Drive the machine straight forward.
Adjuting speed depending working
conditions/quantity of debris.
11. Check the main and side broom and
remove any debris like straps, rope
etc..
If the machine has been used until the Red light illuminates on the battery level indicator on the machine, a full recharge of the batteries (10-12 hours) will be required. Failure to
carry out this this procedure may cause damage to the batteries. Charging the batteries after every use is recommended.
PLEASE ENSURE GREY SOCKET IS LEFT DISCONNECTED AFTER RECHARGE IF THE MACHINE IS NOT TO BE USED ON A DAILY BASIS
OPERATING GUIDELINES
SW900

Nilfisk-Advance A/S
Sognevej 25
DK-2605 Brøndby
Denmark
Tel.: [phone]
Fax: [phone]
mail.com@nilfisk-advance.com
www.nilfisk.com
ATTENTION! Do not use the machine before you have read and understood the User Manual.
The machine
doesn’t work
as it should.
The machine does
not collect debris/
dust
TROUBLESHOOTING
SW900
1. Check if the battery is charged and
that the charger cable is disconnect-
ed from the main.
1. Check if the flaps are correctly ad-
justed and not worn out.
2. Check if the main battery connector
is properly connected.
3. Check if the main circuit breaker is
open.
4. ecure that the upper cover and hop-
per is in the right position.
2. Check if the panel filter is clean the
gasket properly sealing.
3. Check if the gasket is damaged.
The machine do
not sweep.
1. Adjust the main broom position by
the knob.
2 Adjust the side brooms position by
the register screw.
3. Check if there are external materials
avoiding brush rotating.
4. Check if the circuit breaker for side
brooms is open.
4. Check if the hopper is full.
5. Replace the brooms if the bristles are
wornout.