Regency Mia 2000 User manual

Any problems or questions call Regency Ofce Furniture at 1-866-816-9822
IMPORTANT NOTICE:
● Place all wooden parts on a clean and smooth surface such as a rug or carpet to avoid the parts from being scratched.
● Check to be sure that you have all parts and hardware.
● Remove all wrapping materials, including staples & packing straps before you start to assemble.
● Do not tighten all screws/bolts until completely assembled.
● Keep all hardware parts out of reach of children.
Instructions for the Mia #2000
Hardware :
A: Large Bolts (4) • B: Medium Bolts (4) • C: Small Bolts (2) • D: Inserts (4) • L: Allen Key • M: Dowels (8)
Parts :
E: Back Frame F: Seat Frame • G: Wood Frame (2) H: Cross Bars (2) I: Back Cushion J: Seat Cushion
K: Fabric Cover
STEP 1 : Connect the Back Frame(E) to the Seat Frame(F) by using 2 Small Bolts(C).
F
ABCD
K
E
I
J
G
H
E
F
C
LM

STEP 2 : Place the Metal Frame down with the curved side of the headrest facing up. Place the Back Cushion(I) and Seat
Cushion(J) on top of the frame as shown below. Then slide the Fabric Cover(K) over the Frame and Cushions so the opening
of the fabric cover is under the Seat Frame.
The Correct orientation of the cover is essential.
Instructions for the Mia #2000
FE
I
J
The fabric cover opening should be on the frame side after it is
placed over the components above.
STEP 3 : Place the 2 Inserts(D) and 4 Dowels(M) into each Cross Bar(H) with the lines on the inserts pointing toward the
openings. Use 4 Long Bolts(A) to attach the Cross Bars to the Wood Frames as shown below. Face the Inserts toward the
inside of the chair on the front Cross Bar and face the bottom Inserts down.
H
D
D
A
M
M
M
M

Any problems or questions call Regency Ofce Furniture at 1-866-816-9822
STEP 4 : Adjust Fabric Cover(K) so the eyelets on the sides of the cover reveal the bolt holes in the metal frame. Arrange
the Metal Frame with Fabric Cover within the legs of the Wood Frame in preparation to attach the two together with 4 Medium
Bolts(B). Once you have the holes aligned attach the Metal Frame to the Wood Frame as the image shows below. Ensure the
curvature of the headrest faces the user.
Instructions for the Mia #2000
B
B
B
B