SDC SK-82 User manual

Any suggestions or comments to this instruction or
product are welcome. Please contact us through
our website or email [e-mail]
INSTALLATION INSTRUCTIONS
SK-82 FIELD ELECTRIFICATION KIT
SARGENT 8204 MORTISE LOCKSET
801 Avenida Acaso, Camarillo, Ca. 93041 • [phone] • Fax: [phone]
www.sdcsecurity.com • E-mail: [email protected]
P:\INSTALLATION INST\ELECTRIFIED LOCKSETS\INST-SK-82.vsd REV C 11-18 Page 1
Install new Latch Retraction Arm supplied
with Electrification Kit as shown
2
Remove the existing
components shown.
1

+
-
BLK
BLU
12 VDC @ .6 AMP
+
-
RED
WHT
BLK
BLU
24 VDC @ .3 AMP
RED
WHT
Dual Coil Solenoid
Route wires around
post and through
case as shown.
Use cable tie as
strain relief and
position it to avoid
interference with the
lever mounting.
Place Solenoid
Base Plate into
position. Secure
with screw through
existing hole in
back of case.
4
5
Fail Safe or Fail
Secure
(shown)
P:\INSTALLATION INST\ELECTRIFIED LOCKSETS\INST-SK-82.vsd REV C 11-18 Page 2
Fail Safe
Assembly
Remove Locking Bar and
insert Adapter Plate as
shown with supplied screw.
3
Solenoid
Base Plate