Sharp Am-300 User manual

UniNet Imaging does not warrant downloaded information. Unauthorized sale, reproduction or distribution of this article is prohibited. For additional support, please contact [email protected]

www.uninetimaging.com

SHARP®AM-300 •400 •900

EASY TO REMANUFACTURE CARTRIDGE INSTRUCTIONS

SHARP AM-300 •400 •900 TONER CARTRIDGE

1. Remove the two screws from the end cap. 2. Remove the end cap.

SHARP AM-300 •400 •900 EASY TO REMANUFACTURE CARTRIDGE INSTRUCTIONS

UniNet Imaging does not warrant downloaded information. Unauthorized sale, reproduction or distribution of this article is prohibited. For additional support, please contact [email protected]

www.uninetimaging.com

The Sharp AM-900 toner cartridges are rated for 3,000 pages. The part numbers for the cartridge is AM-90D or AM-30DC

outside the US.

There is NO chip used on this cartridge.

NOTE: The developer roller on this cartridge can be removed for a full cleaning but as the doctor blade is very easily damaged,

its better left alone.

REMANUFACTURING THE SHARP

AM-300/400/900 TONER CARTRIDGE

By Mike Josiah and the Technical Staff at UniNet

3. Remove the fill plug and clean out all the remaining toner

from the hopper.

4. Fill the hopper with toner for use in the Sharp AM-90D

(AM-30DC) cartridge, and replace the fill plug.

5. Slide the end cap so it fits over the top tab.

Install the two screws.

SHARP AM-300 •400 •900 EASY TO REMANUFACTURE CARTRIDGE INSTRUCTIONS

UniNet Imaging does not warrant downloaded information. Unauthorized sale, reproduction or distribution of this article is prohibited. For additional support, please contact [email protected]

www.uninetimaging.com

Other manuals for AM-300

This manual suits for next models

Table of contents