Steelcase CPRSLFO User manual

Installation Instructions 21078501 Rev C
Tools required:
Page 1 of 2
#2 Phillips
Power Drill
7/16"
1
Vertical Processor Sling, Fixed Mount
Compatible with c:scape and Frameone worksurfaces
CPRSLFO
Vertical Processor Sling | Installation Instructions
Place base bracket on underside
of worksurface with slot towards
the rear of the desk and base
bracket no more than 1/4" from
the cantilever to allow maximum
clearance between CPU and desk
leg. Install with four (4) 5/8" long
screws (included).
Insert one (1) bolt through sling
support bracket and loosely install
the nut on the opposite side.
Thread straps through sling
support bracket and place
assembly onto the CPU.
SCREW
BASE
BRACKET
SLOT
Setback the base bracket, as shown,
to allow the CPU to be flush with the
front edge of the worksurface.
For example: Setback 6-3/4" when
using an 18" deep CPU.
23
BOLT
NUT
STRAP
2
3
CANTILEVER
1

Page 2 of 2
21078501 Rev C
For further information, please go to the Details website details-worktools.com or call 800.833.0411
P.O. Box 1967 / CD-5E Grand Rapids, MI 49501-1967
©2010 Steelcase Inc. All rights reserved. 11/11
6
7
5
4
LONG SIDE OF SLING
SUPPORT BRACKET
BOLT
6
NUT
Orient sling support bracket on center
of CPU and tighten straps.
NOTE: Long side of sling support
bracket should be placed nearest the
side of the desk.
Align the mounted bolt with the slot in
the base bracket and slide up and to
the rear into position.
Insert second bolt through the empty
hole in the sling support bracket.
Tighten both bolts.
4
5