Uplus Lighting BSW 350 User manual

User manual
BSW 350
Please read the instructions carefully before use

2
TABLE OF CONTENTS
1. Safety Instructions……………………………………………………………………………3-4
2.Technical Specifications…………………………………………………………………………4
3.Control Menu ……………………………………………………………………………………5-6
4.DMX Channels ……………………………………………………………………………………7-10
5.Trouble Shooting…………………………………………………………………………………11
6.Fixture Cleaning………………………………………………………… ………………………11
STATEMENT
The product has well capability and intact packing when leave factory. All of the user should
comply with warning item and manual, any misuse cause of the damages are not included in our
guarantee, and also can not be responsible for any malfunction & problem owing to ignore the
manual.

3
1.Safety Instructions
Please keep this User Guide for future consultation. If you sell the unit to another user, be sure
that they also receive this instruction booklet.
•Unpack and check carefully there is no transportation damage before using the unit.
•Before operating, ensure that the voltage and frequency of power supply match the power
requirements of the unit.
•It’s important to ground the yellow/green conductor to earth in order to avoid electric shock.
•The unit is for indoor use only. Use only in a dry location.
•The unit must be installed in a location with adequate ventilation, at least 50cm from adjacent
surfaces. Be sure that no ventilation slots are blocked.
•Disconnect main power before replacement or servicing.
•Make sure there are no flammable materials close to the unit while operating as it is fire hazard.
•Use safety cable when fixes this unit. DO NOT handle the unit by taking its head only, but always
by taking its base.
•Maximum ambient temperature is Ta: 40℃. DO NOT operate it where the temperature is higher
than this Unit surface temperature may reach up to 85℃. DO NOT touch the housing bare-hand
during its operation. Turn off the power and allow about 15 minutes for the unit to cool down before
replacing or serving.
•the event of serious operating problem, stop using the unit immediately.Never try to repair the unit
by yourself. Repairs carried out by unskilled people can lead to damage or malfunction. Please
contact the nearest authorized technical assistance center. Always use the same type spare parts.
•DO NOT touch any wire during operation as high voltage might be causing electric shock.
Warning:
•To prevent or reduce the risk of electrical shock or fire, do not expose the unit to rain or moisture.
•The housing, the lenses, or the ultraviolet filter must be replaced if they are visibly damaged.
Caution:
•There are no user serviceable parts inside the unit. DO NOT open the housing or attempt any
repairs yourself. In the unlikely event your unit may require service, please contact your nearest
dealer.
Installation:
•The unit should be mounted via its screw holes on the bracket. Always ensure that the unit is

4
firmly fixed to avoid vibration and slipping while operating. And make sure that the structure to
which you are attaching the unit is secure and is able to support a weight of 10 times of the unit’s
weight. Also always use a safety cable that can hold 12 times of the weight of the unit when
installing the fixture.
•The equipment must be fixed by professionals. And it must be fixed at a place where is out of the
touch of people.
2.Technical Specifications
Ballast: E-ballast
Light source: YODN 17R 350w
Color temperature: 8500 k
The life of the bulb: 2000 hours
Voltage: AC110-240v
Frequency: 50 /60 hz
Total power: 420 w
Prism: double prism effect, can be half-color effect
Color wheel: 13 kinds of colors + white, can be a color effect
Gobo wheel: double Gobo wheels , a fixed gobo wheel + a rotation glass gobo wheel
Focus: linear focusing
The linear dimming: 0-100% dimmer
Control signal: international standard DMX512
Channel mode: 16/24 channel model
Protection grade: IP20
Lamps and lanterns of size: 640 * 470 * 640 mm
Net weight: 25kgs

5
3.Control Menu
Menu Operation
On the base of the control panel offers a number of features, such as setting DMX fixture address,
switch the lamp, run the test program, the mode selection.
1
DMX Address
001-512
2
Sys set
DMX Mode
Simple mode 16CH
Standard mode 24CH
Pan Inverse
No
OFF
Tilt Inverse
No
OFF
XY Biackout
No
OFF
Run mode
DMX
Auto
Backlight
60S
Always
Save
Exit
3
Manual
Pan
0-255
Pan Fine
0-255
Tilt
0-255
Tilt Fine
0-255
Pan Tilt Speed
0-255
function
0-255
color
0-255
color Fine
0-255
Effect Speed
0-255
Static Gobo
0-255

6
Rotating Gobo
0-255
Rot Gobo
0-255
Rot Gobo Fine
0-255
Prism
0-255
Prism Rot
0-255
Frost
0-255
Zoom
0-255
Zoom Fine
0-255
Focus
0-255
Focus Fine
0-255
Auto Focus
0-255
Shutter
0-255
Dimmer
0-255
Dimmer Fine
0-255
Exit
4
Infor
5
Factory
Passwords 158
6
Lamp
Lamp Status
OFF
ON
Lamp on power
OFF
ON
EXIT
7
Reset
Reset pan&Tilt
Reset Effect
Reset All
EXIT
8
Disolay
Language
Chinese
English
Disolay flip
YES
NO
touch calibration
EXIT

7
4.DMX Channels
Model - CH16/CH24
CH24
CH16
DMX Value
Function
1
1
0－255
Pan
2
*
0－255
Pan Low
3
2
0－255
Tilt
4
*
0－255
Tilt Low
5
3
0－255
P/T Speed
6
4
Macro function
0－19
Reserve
20－24
230W power
25-29
350W power
30-49
Reserve
50-59
Reserve
60-69
Reserve
70-79
P/T Rotate Off Light
80-89
P/T Rotate On Light
90-99
Reserve
100-109
Reserve
110-119
Reserve
120-129
Reserve
130－139
Lamp
140－149
P/T Reset
150－189
Effect Reset
190－199
Reserve
200－209
whole Reset
210－229
Reserve
230－239
Lamp Off
240－255
Reserve
7
5
Macro Colour
0-127
Linear Colour
128-129
white
130-134
Colour 1
135-138
Colour 2
139-143
Colour 3
144-147
Colour 4
148-152
Colour 5
153-157
Colour 6
158-161
Colour 7

8
162-166
Colour 8
167-171
Colour 9
172-176
Colour 10
177-180
Colour 11
181-185
Colour 12
186-189
Colour 13
190-220
FAST ROTATION - SLOW
ROTATION
221-224
STOP
225-255
SLOW ROTATION - FAST
ROTATION
8
*
0-255
Reserve
9
6
Gobo 1
0-3
white
4-9
Gobo 1
10-15
Gobo 2
16-21
Gobo 3
22-27
Gobo 4
28-33
Gobo 5
34-39
Gobo 6
40-45
Gobo 7
46-51
Gobo 8
52-57
Gobo 9
58-63
Gobo 10
64-69
Gobo 11
70-75
Gobo 12
76-81
Gobo 13
82-87
Gobo 14
88-95
Gobo 1 Jitter
96-103
Gobo 2 Jitter
104-111
Gobo 3 Jitter
112-119
Gobo 4 Jitter
120-127
Gobo 5 Jitter
128-135
Gobo 6 Jitter
136-143
Gobo 7 Jitter
144-151
Gobo 8 Jitter
152-159
Gobo 9 Jitter
160-167
Gobo 10 Jitter
168-175
Gobo 11 Jitter
176-183
Gobo 12 Jitter
184-191
Gobo 13 Jitter
192-199
Gobo 14 Jitter

9
200-201
white
202-227
FAST ROTATION - SLOW
ROTATION
228-229
STOP
230-255
SLOW ROTATION - FAST
ROTATION
10
7
Gobo 2
0
S white
1-4
L white
5-8
Gobo 2 -1
9-12
Gobo 2 -2
13-16
Gobo 2 -3
17-20
Gobo 2 -4
21-24
Gobo 2 -5
25-28
Gobo 2 -6
29-32
Gobo 2 -7
33-36
Gobo 2 -8
37-40
Gobo 2 -9
41-48
Gobo 2 -1 Jitter
49-56
Gobo 2 -2 Jitter
57-64
Gobo 2 -3 Jitter
65-72
Gobo 2 -4 Jitter
73-80
Gobo 2 -5 Jitter
81-88
Gobo 2 -6 Jitter
89-96
Gobo 2 -7 Jitter
97-104
Gobo 2 -8 Jitter
105-112
Gobo 2 -9 Jitter
113-119
L white
120-185
FAST ROTATION - SLOW
ROTATION
186-189
STOP
190-255
SLOW ROTATION - FAST
ROTATION
11
8
Gobo2/Rot
0-127
Rotation
128-190
FAST ROTATION - SLOW
ROTATION
191-192
STOP
193-255
SLOW ROTATION - FAST
ROTATION
12
*
0-255
Reserve
13
9
Prism

10
0-63
empty
64-127
Prism-1
128-191
Prism-2
192-255
Prism-1/Prism-2
14
10
Prism-1/Rot
0－127
Rotation
128－189
FAST ROTATION - SLOW
ROTATION
190－192
STOP
193－255
SLOW ROTATION - FAST
ROTATION
15
11
Prism-2/Rot
0－127
Rotation
128－189
FAST ROTATION - SLOW
ROTATION
190－192
STOP
193－255
SLOW ROTATION - FAST
ROTATION
16
12
Frost
0－64
Reserve
65－255
Linear Frost
17
13
Zoom
0－255
Linear Zoom
18
*
0－255
Zoom Fine
19
14
0－255
Focus
20
*
0－255
Zoom Low
21
*
空
Reserve
22
15
Shutter
0-31
Closed
32-63
Open
64-95
SLOW - FAST
96-127
Open
128-143
FAST STROBE-SLOW STROBE
144-159
SLOW STROBE - FAST STROBE
160-191
Open
192-223
RANDOM SLOW - FAST
224-255
Open
23
16
Dimmer
0－255
Linear Dimmer
24
*
Reserve