VENETA 65101-50725-D Instruction sheet

Inside Video Outside Video
Required Tools
Installing inside the window frame…
At top of window frame, measure 89mm in from each end and
34mm back from the front of the window frame, mark with a
pencil; this is where the screw will go for the outer brackets.
We recommend drilling pilot holes for the screws using a 2mm bit.
Fix the brackets into position using 1 long screw for each bracket.
If more brackets are supplied; on the blind accurately measure
from centre of first bracket to centre of the next bracket and mark
the same distance on window frame.
Installing outside the window frame…
Measure 89mm in from top left and top right of where the blind will
sit (normally edge of architrave) and mark where the screws will go.
We recommend using a spirit level to align brackets if not installing
on the architrave.
We recommend drilling pilot holes for the screws using a 2mm bit.
Fix the brackets into position using 2 long screws for each bracket.
If more brackets are supplied; on the blind accurately measure
from centre of first bracket to centre of the next bracket and mark
the same distance on window frame.
How to install your
#65101-50725-D
Cordless Roman Blind
Included Hardware
measuring
tape
drill with
2mm bit
phillips bit or
screwdriver
pencil knife
The hardware can be found in
the end of every box.
Child Safety
This product has no Cord or
Chain and is Child and Pet
Safe!
1Installation Brackets
Great Job… Enjoy your new Veneta Blinds!
Installation
Bracket
(Install inside
window frame)
Installation
Bracket
(Install outside
window frame)
Bracket
89mm 89mm
Slide blind backwards into position ensuring all brackets meet
snugly.
Note the blind click into place.
3Install Blind
Attach the valance return to the ends of the blind using the
Velcro patches.
2Valance Returns
(inside mount only)
Long Screws for
Wood
Wall Plugs for Brick
or Cement using
a 6mm bit
(if requested)
89
89
Wand
(if requested)

Operating your
Blind
How to operate and maintain your
Cordless Roman Blind
Lower your new Roman blind to the desired position by
gently pulling down on the fabric handle located at
the back of the blind.
To raise the blind, gently pull down on the fabric handle
for a short distance to unlock the spring and the blind
will then rise automatically.
Note: To ensure long-term performance of your blind,
always grab the blind handle when operating the
blind. The handle is located at the back of the blind.
Do not grab the bottom of the blind.
Maintaining your
Blind
Dust can be removed using a feather duster or vacuum with
brush attachment on low suction.
1Dusting
Use a warm damp cloth or a mild detergent for tougher stains.
Dab the affected area, but do not rub the fabric. Finish with
just a warm damp cloth.
Allow the fabric to dry in the lowered position.
2Spot Cleaning
Please write a review on our
website at…
www.venetablinds.com.au
Feedback?
We would love to know how you
went with your installation…
Need HELP?
Customer Service
1300 836 382
“the best compliment
you can give
is a referral”