VENETA Smartfit Day & Night Honeycomb User manual

Installing inside the window frame…
At top and bottom of window frame measure at least 12mm in
from each end and 14mm back from front of window frame and
mark where the screws will go.
We recommend drilling pilot holes for the screws using a 2mm bit.
Fix the Shoe Bases into position using 1 long screw for each Shoe
ensuring the outer edge is to the outside of the window.
Installing outside the window frame…
We recommend using a spirit level for vertical and horizontal
alignment.
Place the blind in position and mark the top corners of the blind.
Measure 4mm down and 5mm in from the top left and top right of
where the blind will sit, and mark the location of the L bracket outer
screws (ensure screws are at least 16mm from window opening).
The measurement from this screw to the screw on the bottom brackets
is the ‘order height’ minus 8mm (order height can be found on the
outside of your box).And mark with a pencil.
Place L brackets in position and mark where the other screws will go.
We recommend drilling pilot holes for the screws using a 2mm bit.
Fix the L brackets into position using 2 long screws for each bracket.
Fix the Shoe Bases onto the L Brackets using 1 short bolt for each shoe,
ensuring the outer edge is to the outside of the window.
How to install your
Smartfit Day & Night Honeycomb Blind (25mm Cell)
Included Hardware
measuring
tape
drill with
2mm bit
phillips bit or
screwdriver
pencil knife
The hardware can be found in
the end of every box.
1Installation Brackets
Wall Plugs for Brick
or Cement using
a 6mm bit
(if requested)
Required Tools
Shoe Base
(For Headrail and
Bottom Rail)
Installation
L Bracket
(Outside Install)
Handle
Short Bolt
Long Screws for
Wood
#65101-11520-A
Extension Pole
(if requested)
L Bracket Cover
(Outside Install)
Shoe Slider
(Attached to blind)
Inner Edge Outer Edge
Difficulty: ★★☆☆☆
1
Attach the handle to the handle support pre-attached on the rail then slide against the handle
support to the left until the handle can’t move anymore.
2Attach Handle
3
2
1

When installing the Shoe Slider, it is suggested to secure the bottom shoe slider first, and then
unfasten the top cord to secure the top shoe slider. Please do NOT untie the top cord until the
bottom shoe slider is secured.
Please note all blind cords are interconnected.
Ensure the cords are not crossed or tangled.
Place Shoe Sliders into centre of Shoe Bases and slide towards the outer edge of Shoe as per
diagram below.
3Install Blind
Installation
continued…
How to install, operate and maintain your
Great Job… Enjoy your new Veneta Blinds!
Please write a review on our
website at…
www.venetablinds.com.au
Feedback?
We would love to know how you
went with your installation…
Operating your
Blind
Lower and raise the blind using the handles on the top, middle and bottom rails.
Note the blind will close firmly at the top utilising the inbuilt magnets.
Maintaining your
Blind
1Dusting
Dust can be removed using a feather duster or vacuum with brush attachment on low suction.
2Spot Cleaning
Use a warm damp cloth or a mild detergent for tougher stains.
Dab the affected area, but do not rub the fabric. Finish with just a warm damp cloth.
Allow the fabric to dry in the lowered position.
3Ultrasonic
If ultrasonically cleaning the blind please specify that a mild solution must be used.
Note the rails should never be immersed in liquid.
2
Smartfit Day & Night Honeycomb Blind (25mm Cell)
Need HELP?
Call our
Customer Service team
for assistance
1300 836 382