Victory 4x4 3RD GEN NISSAN FRONTIER DOOR MOLLE PANEL User manual

3RD GEN NISSAN FRONTIER
DOOR MOLLE PANEL
Thank you for purchasing from Victory 4x4! Checkout our website, victory4x4.com for other great o-road
products. Be sure to rate and review our product online. If you have any questions or are missing parts, please
don’t hesitate to call us at 269-459-8447!
INSTALL INSTRUCTIONS
Please read the mounting instructions below carefully before attempting to install.
Be sure to check out the install video on the product page, if available.

INCLUDED HARDWARE
Black Nylon 1/2” OD
3/8” Long Spacer
8x
Black Philips Head
18-8 Stainless Steel
3/4” Long Screw
8x
Note: Some Victory 4x4/JCR Oroad/SquatchProof products share hardware kits. Any extra hardware you may
recieve that is not listed above can be reurposed or discarded.
INCLUDED BOLT PACK(S) 046-0044

INCLUDED PARTS
2x
OR
2x
FRONT
REAR

1. Start by lining up the panel up on the side of your door panel on either the
driver or passenger side, and align it visually to your liking trying to match
the curve and spacing, as shown below (driver side). When the panel is
lined up to your liking, then take a punch or a philips head screw driver and
apply pressure to mark the four smaller mounting holes in the plastic.
INSTALLATION
FRONT
REAR

2. Once the pilot holes are marked, you can remove the panel. Take the
provided screws and start to thread them into the locations just marked
in the plastic. Once the holes are established with the screws, remove the
screws in preparation for the final installation. Make sure not to punch too
far through the plastic. You can also use a drill with a 1/16” drill bit to start
your holes.
INSTALLATION
3. Aer the holes are started, place the panel back in line with the holes and
place the provided spacers behind the panel. You can then start to thread
the screws into the plastic with a screwdriver until all four are snug and the
panel is secure, be sure not to over tighten.
FRONT

4. That’s it! Now you’re equipped with a sturdy mounting location for your
desired fast-access gear. Please visit us at www.victory4x4.com for other
made-in-the-US armor and storage options.
INSTALLATION
REAR