Victory 4x4 VTC-MPX-PC Configuration guide

ROTOPAX/MAXTRAX
CARRIER
Thank you for purchasing from Victory 4x4! Checkout our website, victory4x4.com for other great o-road
products. Be sure to rate and review our product online. If you have any questions or are missing parts, please
don’t hesitate to call us at 269-459-8447!
INSTALL INSTRUCTIONS
Please read the mounting instructions below carefully before attempting to install.
Be sure to check out the install video on the product page, if available.

INCLUDED HARDWARE
3x
1/2”-13 X 1”
Button Head
3x
1/2”-13
Serr. Flange Nut

INCLUDED PARTS
1x

1
INSTALLATION
To install the MAXTRAX/ROTOPAX carrier, simply bolt it into any of the
columns of slots on the Adventure Carrier. Do this using the 1/2”-13 X 1”
button head bolts and 1/2”-13 serr. flange nuts.

INSTALLATION
2If you are installing a ROTOPAX, attach the mount to one of the sets of
slots using the hardware that comes with it. If you are mounting a larger
ROTOPAX, you will need to attach a mount to each of the sets of slots.

INSTALLATION
3If you are mounting a MAXTRAX, you will need a TRACBO-BP. Insert a
carriage bolt provided in the bolt pack through each of the four larger
holes and place your MAXTRAX over them so that the bottom two bolts
go through the small mounting holes on the bottom of the board and the
top bolts go through the middle handle. Then, secure it in place using the
plastic spacer, washer, and wingnut provided in the bolt pack as shown
below. Notice that the order of the hardware is dierent on the top bolts
than the bottom bolts.