Victory 4x4 ARMREST INTERIOR MOLLE PANEL Configuration guide

2ND & 3RD GEN TUNDRA (07-21) &
2ND GEN SEQUOA (08+)
ARMREST INTERIOR
MOLLE PANEL
Thank you for purchasing from Victory 4x4! Checkout our website, victory4x4.com for other great o-road
products. Be sure to rate and review our product online. If you have any questions or are missing parts, please
don’t hesitate to call us at 269-459-8447!
INSTALL INSTRUCTIONS
Please read the mounting instructions below carefully before attempting to install.
Be sure to check out the install video on the product page, if available.

INCLUDED HARDWARE
Black Nylon 1/2” OD
3/8” Long Spacer
4x
Black Philips Head
18-8 Stainless Steel
3/4” Long Screw
4x

INCLUDED PARTS
1x

1. Start by lining up the panel up on the interior of your armrest on either
the driver or passenger side, and center it visually to your liking, as shown
below (passenger side). When the panel is lined up to your liking, then take
a punch or a philips head screw driver and apply pressure to mark the four
smaller mounting holes in the plastic.
INSTALLATION

2. Once the pilot holes are marked, you can remove the panel. Take the
provided screws and start to thread them into the locations just marked
in the plastic. Make sure not to punch too far through the plastic. You can
also use a drill with a 1/16” drill bit to start your holes, making sure not to
punch through the plastic.
INSTALLATION
3. Aer the holes are started, place the panel back in line with the holes and
place the provided spacers behind the panel , as shown below. You can then
start to thread the screws into the plastic with a screw driver until all four
are snug and the panel is secure, be sure not to over tighten.