Victory 4x4 4Runner Roof Rack User manual

TOOLS NEEDED HARDWARE
4RUNNER ROOF RACK
INSTALLATION INSTRUCTIONS
• Pry tool
• 3/16 allen
• 5/32 allen
• 12mm socket
• 1/4” 20x3/4 button head hex drive screws qty. 56
• 1/4” 20 thread serr flange nut qty. 24
• 18-8 SS washer 1/4” screw size qty. 56
• M8-1.25-25 mm Butt Head Soc Cap 18-8 qty. 8
• 316 SS Washer M8 Screw size 8.4mm ID 16MM OD qty. 8
• Rubber push in bumper qty. 4
Please read the instructions below carefully before attempting to install.

Assemble the rack on the ground. Start by assembling the crossbars to the
side rails using the small button head bolts and small washers (2 per side).
Make sure the machined hole in the rail of the crossbar is facing upward so
you can easily add t-nuts to mount your gear.
Mount the front and rear fairing. Use the small button head bolts along with
the small washers and a ange nut. Adjust the fairings all the way up, for
now, to avoid contact with the roof when you set the rack in place.
Front fairing - 3 bolts per side
Back fairing - 2 bolts per side
1.
2.

Use a pry tool to remove the 4 caps on the stock rails. Use a 12mm socket
to remove the bolts holding the rails in place.
3.
Insert 2 rubber bumpers into each front mount, then install the mount to the
rack using 2 button head bolts, washers, and ange nuts. The mount will
install on the inside of the rack. Pull the front section of the factory rubber
in the gutter so you can trim and reinstall on either side of the mount later.
They will sit inside the gutter on the roof. They are a tight t with the rubber
feet, so press the mounts into the gutter and the rubber feet will squeeze
into it.
4.

Install the rear mounts with the V-shape facing upward. Use 2 button head
bolts, washers, and ange nuts.
6.
With the rack assembled, have a friend help you life the rack into place. 7.
Lift the factory rubber so you can place the middle mount and see where
you’ll have to trim it. Then install the middle mounts onto the rack with
the long end facing toward the front of the rack. Use 2 button head bolts,
washers, and ange nuts.
5.

Once you have the hardware tight on the roof you can tighten the hardware
on the side rails and the crossbars using a 5/32 allen.
9.
With the rack in place, use RTV and spread it under the mounts and ll the
bolt holes. Use the larger bolts and washers to secure the rack to the roof
using a 3/16 allen. You should see RTV squeeze out under the bolt heads
when you tighten them, this will prevent any leaking. Be sure not to over
tighten the mounting bolts.
8.

Use the trim we provide and cover the lower part of the front fairing
(approx. 41 inches). Use the remaining trim on the back. We recommend
cutting it in half and placing the trim on either end of the back fairing.
With the trim installed, you can now loosen and lower the front and rear
fairing down until it touches the roof, then tighten the bolts.
10.
11.
We recommend using 3M Paint Protection Film (or similar) below the
fairings. This will protect the paint from dust/debri and wear from the
rubber.