Victory 4x4 3RD GEN TUNDRA 14-21 Configuration guide

3RD GEN TUNDRA (14-21)
DOOR MOLLE PANEL
Thank you for purchasing from Victory 4x4! Checkout our website, victory4x4.com for other great o-road
products. Be sure to rate and review our product online. If you have any questions or are missing parts, please
don’t hesitate to call us at 269-459-8447!
INSTALL INSTRUCTIONS
Please read the mounting instructions below carefully before attempting to install.
Be sure to check out the install video on the product page, if available.

INCLUDED HARDWARE
Black Nylon 1/2” OD
3/8” Long Spacer
8x
Black Philips Head
18-8 Stainless Steel
3/4” Long Screw
8x

INCLUDED PARTS
2x

1. Start by lining up the panel up on you door in the area between the cubby
and the arm rest, as shown below (driver side). When the panel is lined up
to your liking, then take a punch or a philips head screw driver and apply
pressure to mark the four smaller mounting holes in the plastic.
INSTALLATION

2. Once the pilot holes are marked, you can remove the panel. Take the
provided screws and start to thread them in to the locations just marked.
Make sure not to punch too far through the plastic. You can also use a drill
with a 1/16” drill bit to start your holes, making sure not to punch through
the plastic.
INSTALLATION
3. Aer the holes are started, place the panel back in line with the holes and
using the provided spacers, as shown below (driver side), start to thread
the screws into the plastic with a screw driver until all four are snug and
the panel is secur, be sure not to over tighten. Repeat this process for the
other side.