Victory 4x4 VRKAWN2 User manual

ROOF RACK
AWNING MOUNT
Thank you for purchasing from Victory 4x4! Checkout our website, victory4x4.com for other great o-road
products. Be sure to rate and review our product online. If you have any questions or are missing parts, please
don’t hesitate to call us at 269-459-8447!
INSTALL INSTRUCTIONS
Please read the mounting instructions below carefully before attempting to install.
Be sure to check out the install video on the product page, if available.

INCLUDED HARDWARE
8x
1/4"-20 X .75"
Slide-In T-Stud
8x
1/4"-20
Locknut
Note: Some Victory 4x4/JCR Oroad/SquatchProof products share hardware kits. Any
extra hardware you may recieve that is not listed below can be repurposed or discarded.
INCLUDED BOLT PACK(S) 046-0114

INCLUDED PARTS
2x

1. To install, start by sliding (2) of the provided slide in T-studs into the slots
on each of the shorter sides of the crossbar, as shown below. If you have
already installed the crossbar into your roofrack, you will need to take the
bolts out of that end in order to be able to li it out enough to slide the
T-studs in. Then, slide the awning mount over the studs in the crossbar and
use the provided 1/4”-20 locknuts to secure the mount to the crossbar.
Once you have one installed, repeat for the other at the correct distance
for your awning. You may need adjust the position of the cross bars to fit
your awning.
INSTALLATION