Victory 4x4 VT23SL-BL User manual

TOOLS NEEDED HARDWARE
TACOMA BLITZ SLIDER
INSTALLATION INSTRUCTIONS
• 14 mm socket
• 12 mm socket
• 1/2” wrench
• pry tool
• 5/16-18 x 3/8” Hex Head Bolt qty. 8
• 1/4-20 x 3/4” Button Head qty. 12
• 1/4-20 Flange Nut qty. 12
• 1/2-13 x 1” Button Head qty. 16
• 1/2-13 Flange Nut qty. 16
Please read the instructions below carefully before attempting to install.

First we will assemble the slider. Lift the legs onto the slider and bolt them
on with the large button head bolts and ange nuts. Look at the corner of
the leg and make sure the arrow is pointing toward the front of the vehicle.
Note: you will have to drill a hole in the bottom of the rear bracket on the long bed slider for
maximum strength.
Install the light brackets. Press the LED grommets into the brackets. It may
help to warm the grommet with a heat gun if you are in a cold area.
1.
2.
Once the grommets are in place, pop in the LEDs.

Bolt on the logo accent plates using a button head stainless bolt and a
ange nut (3 bolts per plate).
3.
Install the light brackets. You’ll notice the bracket is larger on one side,
make sure the larger side is facing upward. Secure the bracket to the slider
using a 5/16” bolt and a 1/2” wrench. The legs that connect to the slider
have holes drilled into them for you to run wire to your lights.

Install the rest of the button head bolts to mount the legs to the slider.
Leave the bolts loose so you can move the slider back and forth to align
it on the truck once its mounted. From this point on, they will mount to the
truck in the same way as our Strike Rock Sliders
4.
Remove the bolt that connects the crossmember to the frame rail. Use a
14mm socket to remove the bolt. Use a pry tool to move the wire harness
out of the way.
Use a pry tool to remove the plastic cap and the black sticker.
5.
6.

Take the plate we provide and slide it into the square hole in the
crossmember. Use a 12mm and remove the two nuts holding the electronic
box inside the frame rail. Move the electronic box out of the way.
With the slider jacked into place, replace the bolt that we removed earlier
with the bolt that we supply in the same crossmember. Loosely install this
bolt.
7.
9.
Use a jack to lift the slider into place. Make sure the wire harness is out of
the way before bolting the slider to the frame.
8.

Loosely install the ve side mount bolts. Use the 1/2” bolts and install them
inside facing outward. Use a 1/2” bolt with a 1/2” washer, then back it up
with a 3/4” washer on the inside of the rail and use a 1/2” washer and a
1/2” nut. If the brake line is touching the bolt, carefully ex the line upward
so it doesnt rub agaisnt the bolt.
10.
11. Remove the brake line brakcet using a 12mm socket then pop the brake
line out of the frame to give yourself room to insert the bolt. You will need to
stick your arm into the frame so prepare the bolt with the washers to make
this process easier.

Next, use a magnet to insert the 1/2” nut through the frame hole. Then
thread the 1/2” bolt through the bottom hole and into the nut. Use a 3/4”
socket to tighten it down.
12.
Reconnect the brake line brackets and the electric box. Go back and
tighten down all of the bolts then you will be nished with the install.
13.