XMark Fitness 3 tier Dumbbell Rack User manual

Owner’s Manual
3 tier Dumbbell Rack
6/21

2
Table of Contents
3
4
5
6
Before You Start
Important Safety Information
Assembly
Parts List/Exploded View

Before You Start
3
THANK YOU for making this unit a part of your exercise
program. XMark assures the very best in value, appearance,
durability and biomechanics.
QUESTIONS?
EMAIL: [e-mail]
This manual will guide you through the assembly process. If at any time youu are
having trouble with the assembly or use of this product, please contact us at
[email protected]. We have trained service technicians on site to take
care of you, our valued customer.

SAFETY INFORMATION WARNING!
Before using this unit or starting any exercise program, consult your physician. This is
especially important for persons over the age of 35 and/or persons with pre-existing
health problems. XMark assumes no responsibility for personal injury or property
damage sustained by or through the use of this product.
It is the owner’s responsibility to ensure that all users of this unit have read the
Owner’s Manual and are familiar with safety information and precautions.
SAFETY PRECAUTIONS
Important Safety Information
4
•This unit should only be used on a level surface and is intended for indoor use only.
XMark recommends an equipment mat be placed under the unit to protect the floor or
carpet and for easier cleaning.
•Do not leave children unsupervised near or on the unit.
•Service to your unit should only be performed by an authorized service representative,
unless authorized and/or instructed by a XMark technician. Failure to follow these
instructions will void the warranty.

1
1.
2
2
3
2.
3.
Assembly
5
1
4
4
4
4
4
48
8
8
9
9
9
9
9
9
11
11 11
11
11
2
Tighten all bolts properly before using the
equipment.
1
10
3
12
11
Attach the Right Upright (#1) to the Base (#3)
using:
•4 x M10 x 70mm Bolts (#10)
•1 x Plate (#12)
•4 x M10 Locknuts (#11)
Hand tighten bolts until assembly is
complete.
3
10
12
11
Attach the Left Upright (#2) to the Base (#3) using:
•4 x M10 x 70mm Bolts (#10)
•1 x Plate (#12)
•4 x M10 Locknuts (#11)
Hand tighten bolts until assembly is
complete.
Attach the Rack Supports (#4) to the Left and
Right Uprights using:
•12 x M10 x 63mm Bolts (#8)
•12 x M10 Washers (#9)
•12 x M10 Locknuts (#11)
4.
Prior to assembly remove components
from the box and verify that all the
listed parts were supplied.

Part Lists/Exploded View
6
12
12
K e y N o . D e s c rip tio n Q ty . K e y N o . D e s c rip tio n Q ty .
1 Right Upright 1 7 Square End Cap 4
2 Left Upright 1 8 M10 x 63mm Bolt 12
3 Base 2 9 M10 Washer 12
4 Rack Support 6 10 M10 x 70mm Bolt 8
5 50mm Inner Cap 2 11 M10 Locknut 20
6 44mm Inner Cap 12 12 Plate 2

www.xmarkfitness.com