Assa Abloy ML22HPH User manual

ML22HPH, ML32HPH, ML22HPV, ML32HPV
INSTRUCTIONS
An ASSA ABLOY Group brand
CHANGING THE MASTER-CODE
1. Press for 4 seconds (green LED starts to blink)
2. Enter Master-code (factory setting 1111) and press
3. Enter new Master-code (4 - 12 numbers) and press
4. Enter new Master-code again and press
Short melody and LED blinks several times when changed successfully.
Note. Master-code must be changed before adding User-code.
ADDING USER-CODE
Enter User-code (4 numbers)
or
Press and enter User-code (5 - 12 numbers) and press
Short melody and LED blinks several times when changed successfully.
Note. Opening with the Master-code will delete the User-code.
CHANGING THE USER-CODE
1. Enter User-code and press
2. Enter new User-code (4 numbers)
or
2. Press and enter User-code (5 - 12 numbers) and press
Short melody and LED blinks several times when changed successfully.
OPENING WITH THE MASTER-CODE
+ Master-code +
OPENING WITH THE USER-CODE
User-code
MELODY OFF
and pressed
simultaneously for 2 seconds
MELODY ON
and pressed
simultaneously for 2 seconds
RESET (if there is unknown problem and lock does not work. Does not delete codes)
Press and simultaneously (Short melody and green and red LED blinks)
2.9.2015 Rev.0
CARE INSTRUCTIONS
Use a damp, soft cloth for removing stains and fingerprints from the lock. For grease and other accumulated dirt
use cloth with mild cleaning agent. The lock does not need to be greased.
Copyright® Abloy Oy Joensuu Factory

OUT OF BATTERY
There will be battery warning alarms, 5 beeps, while opening and closing the lock.
Use 3x 1,5V AAA alkaline batteries only. Batteries last for 3 years.
A standard DC 5V charger with Micro USB cable can be used to supply the power.
USB-connector
An ASSA ABLOY Group brand
PROBLEM SITUATIONS
1. Couple the “Reset” points with sharp tweezers or similar.
2. press and simultanously.
3. Remove “Reset” coupling.
Short melody and LED blinks several times after reset.
Master-code resets to 1111.
RESET TO FACTORY SETTINGS
EMERGENCY OPENING
Use emergency opening if the lock does not work at all (breaks the lock).
1. Drill the lock at the spot as shown in pictures below.
2. Remove the knob and open the lock with the screwdriver.
ø2
Min. 39 mm
Spot
ø2
Min. 39 mm
Spot
Copyright® Abloy Oy Joensuu Factory