Biotage V-10 Touch User manual

© Biotage 2016
Biotage®V- Touch Quick Guide | Page 
Biotage®V-10 Touch Quick Guide
Success with Evaporation
Biotage®V Touch is a solvent evaporator system for applications in organic and
inorganic chemistry. The evaporator is operated via its touch screen.
Set UpYour Vial
Shown in actual size, simply hold your prepared vial up to the
photo to check for proper filling.
Defrosting Condenser
As the condenser accumulates ice it becomes less efficient. If
ice has built up, a defrost operation must be performed. Do so
as often as required. After the defrost operation is completed,
the condenser will be drained. A drain will occur even if you
cancel the defrost operation before it is completed.
» Select Maintenance from the menu bar
» Press Defrost
» Press the Defrost Time field and enter the defrost time
Cleaning
Clean the exterior of the system as often as required. If the
touch screen has been contaminated by chemicals, it must be
cleaned immediately. Please see Maintenance section in the
User Manual for further details.
Quick Guide UI.v
29 mm
(12 mL)
30 mL Vial
18 mm
(8 mL)
20 mL Vial 16 mL Vial
30 mm
(8 mL)
8 mL Vial
26 mm
(4 mL)
4 mL Vial
17 mm
(2 mL)
Redissolve Conguration System Ready
Last Run: 2 min, 35 sec
MaintenanceEvaporate
Defrost
Defrost
Defrost Time
Drain Time
Remaining Time
15 min
1 min
--
Back

© Biotage 2016
Biotage®V- Touch Quick Guide | Page 
EUROPE
Main Office: [phone]
Toll Free: [phone]
Fax: [phone]
Order Tel: [phone]
Order Fax: [phone]
[e-mail]
Support Tel: [phone]
Support Fax: + 46 18 56 57 11
[e-mail]
NORTH & LATIN AMERICA
Main Office: [phone]
Toll Free: [phone]
Fax: [phone]
Order Tel: [phone]
Order Fax: [phone]
[e-mail]
Support Tel: [phone]
Outside US: [phone]
[e-mail]
JAPAN
Tel: [phone]
Fax: [phone]
[e-mail]
[e-mail]
CHINA
Tel: [phone]
Fax: [phone]
[e-mail]
[e-mail]
To locate a distributor,
please visit our website
www.biotage.com
Part Number: UI336.v2
© 2016 Biotage. All rights reserved. No material may be reproduced or published without the written permission of Biotage.
Information in this document is subject to change without notice and does not represent any commitment from Biotage. E&OE.
A list of all trademarks owned by Biotage AB is available at www.biotage.com/legal. Other product and company names mentioned
herein may be trademarks or registered trademarks and/or service marks of their respective owners, and are used only for
explanation and to the owners’ benefit, without intent to infringe.
Methods For Various Solvents
Solvent Name Alternative Name Boiling Point (°C) Method
1,2-Dichlorobenzene 179.0 Very hi boil1
1,2-Dichloroethane DCE 83.5 Volatile
1,4-Dioxane 1,4-diox 101.5 Aqueous
1-Methyl-2-pyrrolidinone NMP 202.0 Very hi boil1
Acetic acid HOAc 117.9 Hi boil1
Acetone Propanone, 2-propanone 56.1 Volatile
Acetonitrile ACN MeCN 81.6 Volatile
Ammonia NH333.3 Hi volatile
Butan-1-o l n-BuOH 117.7 Aqueous
Butan-2-ol 99.5 Aqueous
Chloroform 61.1 Volatile
Dichloromethane DCM 40.0 Hi volatile
Diethyl ether 34.5 Hi volatile
Dimethyl sulfide 37. 3 Hi volatile
Dimethyl sulfoxide DMSO 189.0 Very hi boil1
Ethanol EtOH 78.2 Volatile
Ethyl acetate EtOAc, AcOEt 7 7.1 Volatile
Formic acid HCOOH 101.0 Aqueous
Heptane 98.5 Aqueous
Hexane 68.7 Volatile
Isopropanol IPA (isopropyl alcohol), Propan-2-ol 82.3 Volatile
Methanol MeOH 64.6 Volatile
Methyl t-butyl ether MTBE, t-butyl methyl ether 55.2 Hi volatile
N,N-Dimethylacetamide DMA or DMAc 165.0 Hi boil1
N,N-Dimethylformamide DMF 153.0 Hi boil1
Pentane 36.1 Hi volatile
Propanoic acid Propionic acid 141.2 Hi boil1
Pyridine 115.2 Aqueous
Tetrahydrofuran THF 65.0 Volatile
Toluene PhMe 110.6 Aqueous
Trifluoroacetic acid TFA 73.0 Volatile
Trimethoxymethane TMM (trimethyl orthoformate) 104.0 Aqueous
Water H2O100.0 Aqueous
1The method is by default set to use an external vacuum pump, if enabled in the system settings.