ELRO AG40SR11A User manual

INTRODUCTION ELRO Home Alarm Indoor Siren AG40SR11A:
The ELRO AG40SR11A Home Indoor Siren is designed for use with the Home Alarm System AG4000,
and incorporates the functions of both a siren and a strobe light into one unit. Two sound levels are
selectable – 90dB and 100dB. When the unit receives an RF command, it will either activate its siren
and flashing light or disable these alarms. 1=LED Indicator
2=Red Strobe Light
3=Sound Level Jumper
4=Tamper Jumper
5=Tamper Switch
6=Learning Key
7=DC Jack
Installing the Home Alarm Indoor Siren:
First, remove the back plate of the unit by unscrewing the screw at the bottom. Then place the four
included 1.5V alkaline LR14 batteries in the fashion indicated in the battery compartment. If
necessary, an optional 600mA @ 6V DC power adapter can be purchased. When battery power is
low, you will see a flashing red strobe light at 8-25 second intervals. When you see this, replace the
batteries as soon as possible. Use the back plate as a template to mark three mounting holes on the
wall. After drilling the mounting holes in the wall, attach the back plate to the wall using the included
wall plugs and screws.
Binding the Home Alarm Indoor Siren to the AG4000 Alarm System
By default, sirens are disabled on the alarm panel. To successfully bind the siren, sirens have to first
be enabled.
The way of doing this is as follows:
Press PIN + 04 + PARM
After this, the user will see numbers on the panel light up. If the number 0 is lit up, the panel and
siren are ready to be paired.
IMPORTANT
If the number 0 doesn’t light up, press 0 + PARM to enable & save the pairing function.
Now take the following steps to bind the siren to the alarm system:
1. Disarm the panel by entering your PIN + DISARM key
2. In the siren, press and hold the learning key for at least three seconds and then release. The
learning LED will flash once per second.
3. Within 30 seconds, on the alarm panel, enter the PIN + DISARM Key.
4. Refer to table below for how the result of binding is indicated:
Binding outcome
Indicator on Siren
Status
Successful
LED
Learning LED blinks once
Sound
A single beep
Failed
LED
Learning LED flashes 3 times
Sound
Three rapid beeps

Changing the sound level and disabling the tamper switch
It is possible to change the sound level and to disable the tamper switch by using the jumpers
underneath the back plate. To change the sound level of the siren from 100dB to 90dB, remove the
cap on the top jumper. To disable the tamper switch, remove the cap on the bottom jumper. You can
see what is top and what is bottom by using the arrow pointing up on the inside of the back plate.
Placing these caps back on the jumpers will reverse these changes.
IMPORTANT WARNING:
This package can contain small parts and/or material which can be dangerous to small
children! Be aware of this, and keep this away from small children!
For more information about the AG4000 ELRO HOME ALARM SYSTEM visit
www.elro.eu
SPECIFICATIONS
Power adapter
(option)
600 mA@6V DC
Battery Type
1.5V LR14 x 4
Battery Life
About 1 year, @ 25°C standby mode