ELRO PRO AP55SR11B User manual

INTRODUCTION ELRO PRO OUTDOOR SOLAR SIREN AP55SR11B:
The PRO Outdoor Solar Siren AP55SR11B is designed for use with the ELRO 10-ZONE PRO ALARM
SYSTEM AP5500.
Outdoor Solar Siren:
The Siren, Strobe Lights and Solar Panel are all
encapsulated within a tough polycarbonate
housing. This
housing provides full protection against adverse weather conditions. All electronic
components inside are specially
treated to ensure long, reliable, trouble free operation and an
integral tamper switch gives maximum security
protection to the unit.
Rechargeable Battery:
The Solar Siren is powered by a high capacity rechargeable battery. A Solar Panel mounted on the top
of the housing
charges the battery during daylight hours. During darkness, only a small amount of
energy is required to
maintain the Solar Siren unit. An Alkaline 9V PP3 battery is supplied in the Siren
& Strobe
unit to provide the initial power to the system.
Best place to install:
The Siren & Strobe unit should be fitted to the outside of the building in a position that is clearly
visible and at a
height which is relatively inaccessible to an intruder. Avoid shadow from trees
X north Test if the location where you want to mount the siren is in
West East reach of the Alarm Panel !
South
Installation:
Remove the fixing screw from the base of the housing and carefully hinge off the front cover.
Use the rear back-plate as a template to mark the position of the four fixing holes on the external
wall. Drill four 6mm holes and insert the plastic wall plugs. Mount
the back-plate using the four
screws provided
Siren House Code:
Under the DIP switch cover you will find a series of miniature dip switches. When the Siren is
viewed as shown above
the dip switches are ‘upside down’. Set the dip switches 1-8 to your
house code. And set DIP 9 on OFF for 1 minute and ON for 3 minutes alarm duration! Connect the
9V PP3 initial power-up
battery to the clip-on connectors. Connect the rechargeable battery
to the charging leads red to red (+)
and black to black (–). Fit the siren and strobe cover to the

back plate and secure using the fixing screw. The strobe lamp will flash to confirm that the
tamper switch has been closed. The installation of your Siren & Strobe
is now complete.
Solar panel
3 screws from DIP switch cover
Tamper switch
Battery connection
Initial Power Up
Battery 9 Volt
House Code Alarm duration
DIP 1-8 DIP 9
Unit / Siren
Service Mode:
Press and hold the bottom button on the Remote Control. The Siren will produce two short
beeps/LED flashes and
then after approximately 6 seconds a single long beep/LED flash
followed immediately by two short
beeps/LED flashes to indicate that it has switched into
Service Mode. Now you can open the siren for service. At least once a year, preferably in the
autumn, the solar panel on the top of the siren housing should be cleaned
using a soft, damp cloth.
This operation will ensure that the
solar panel receives all of the available light.
Operating Mode:
Press and hold the middle button on the Remote Control. After approximately 6 seconds the
Siren will produce a
single long beep/LED flash to indicate that it has switched into normal
operating mode.
For more information about the ELRO 10-ZONE PRO ALARM SYSTEM AP5500 visit www.elro.eu