ELRO AS90SRB User manual

jK
AS90SRB Manual EN Version 1
USER MANUAL
OUTDOOR SIREN & FLASH
ACCESSORY HOME+ALARM SYSTEM
Home is not a place, it’s a feeling
AS90SRB

- 1 -
Inhoud
1. Introduction ................................................................................................- 2 -
2. Description of the facade box.....................................................................- 2 -
3. Pairing the facade box.................................................................................- 3 -
4. Setting the facade box/Status indication....................................................- 3 -
5. Removing the facade box from the app .....................................................- 5 -
6. Frequently Asked Questions .......................................................................- 5 -
7. Specifications ..............................................................................................- 5 -
8. DoC..............................................................................................................- 6 -
9. Symbolen.....................................................................................................- 6 -

- 2 -
1. Introduction
The AS90SRB wireless facade box is a very powerful 115dB siren with flashing light. Mounting it
on the facade of your home shows potential burglars that you are protected against burglary.
The facade box is easy to install and comes with a spirit level so you can mount it neatly
straight on the outside wall. Screws and plugs are included. If the Home+ Alarm System is
switched on or in night mode, then the AS90SRB wall box is tamper-proof. The center LED
lights up once every 9 seconds and a push message is sent to the app on your smartphone if
the batteries run out.
2. Description of the facade box
1LEDs 1 to 4 light up if the system is set to Home Arm .
2LEDs 5 to 8 light up when the system is switched ARM .
3LEDs 1 to 8 light up when the system is switched Disarm .
4LEDs 1 through 8 flash very brightly if ALARM/S.O.S. is triggered .
5Flashes when batteries run low and lights continuously when an adapter is connected.
6115dB siren output.
7Tamper protection against unauthorized opening.
8Tamper protection against vandalism.
9ON/OFF switch.

- 3 -
10 12V DC adapter (excl.) connection.
11 Press to perform a manual test.
12 Reset button.
13 Battery compartment; 3 x size D 1,5V included.
14 Level; help with mounting.
15 Input for adapter cord.
16 Opening the wall box.
3. Pairing the facade box
•The Home+ alarm system must be deactivated during the pairing and installation of the wall
box. Open the facade box by unscrewing the screw on the bottom. Insert the 3 batteries,
paying attention to the polarity (+ and -). Make sure that the ON/OFF switch is set to ON. The
LEDs will flash, wait about 5 minutes until the LEDs have stopped. If the LEDs do not flash but
are lit continuously, press the reset button until the wall box gives a signal and the LEDs still
flash.
•Open the app and tap "Add accessories" (1).
•Scan the QR Code on the back of the wall box (2).
•Give the wall box a name, for example the location (3) and confirm with the blue "V" (4).
•You get a confirmation; the siren of the wall box gives 2 "Beep" signals and the LEDs go on and
off.
4. Setting the facade box/Status indication
You can set up the panel according to your personal preferences, such as how long and how
loud the siren should sound. You can also use the app to set the panel to flash the LEDs (1 x 15
seconds) to indicate the status of the Home+ alarm system. See also 2. Description of the
facade box

- 4 -
Advice: If you use this status signaling, we recommend you to use a 12V DC adapter to save the
batteries, in this case the batteries serve as emergency power supply. Act as follows to get to
the "Siren Settings" menu.
•Tap the cogwheel (5), then the wireless siren (6) and finally select the appropriate wall box, in
this case the outside wall, tap the "i" (7).
•Tap "Siren settings" (8) to enter the menu, remember to confirm with the blue "V" (9) after
you have changed a setting.
•Testing from the app is very easy, just tap test (10) in the "Accessory settings" menu of the
"Exterior facade" box.

- 5 -
5. Removing the facade box from the app
•The link can be removed by sliding the "i" to the left and tapping delete (11). Even though the
link is broken it may take a while for the information in your app to disappear.
6. Frequently Asked Questions
I am unable to pair the AS90SRB wall box with an iOS smartphone.
•Please try the installation with an Android smartphone/tablet. After installation, the façade
box will automatically be available for your iOS device.
Every 9 seconds a LED flashes on the wall box what does this mean?
•This means that the batteries have run out of power and need to be replaced. The system must
be turned off before you replace the batteries.
What is the life span of the batteries?
•This depends on your personal settings. See also: 4. Setting the wall box/Status signaling.
Can I connect multiple sirens?
•You can connect multiple wall boxes AS90SRB and indoor sirens AS90SRA. Make sure they have
a (location) name in the app. You can make a separate setting for each wall box or indoor siren.
7. Specifications
Power Supply
Battery 3x D(LR20) batteries are included
Or DC12V 1A (adapter not included –plug 5,5 mm)
Wireless Transmitting Distance
up to 300m without obstacle
Standby Current
≤110 uA
Operating Current
≤400 mA
Siren Volume
115dB@30cm
Lens Color
Red/Blue
Temperature
-20°C~60°C
Humidity
90%rh (non-condensing)
IP Resistance
IP54
Mounting level
Yes
Tamper-proof
Yes
Led & Volume adjustment
Yes
Housing material
PC+ABS+Anti-UV
Expected battery life
12 months
Weight
950.7g (batteries not included)
1369.8 (batteries included)
Dimensions
277 mm x 235 mm x 70 mm

- 6 -
8. DoC
-I, ELRO Europe, hereby declare that the radio equipment type AS90SRB conforms to
Directive 2014/53/EU. The full text of the EU Declaration of Conformity can be found at the
following internet address: www.elro.eu/compliance"
-Frequency: 2.4GHz-2.4835GHz
-Maximum transmitting power: 19dBm
9. Symbolen
Recycling and Disposal: The WEEE symbol means that this product and batteries must be
disposed of separately from household waste. When this product reaches the end of its
life, take it to a designated waste collection point nearby to ensure safe disposal or
recycling. Protect environment and public health, handle natural resources responsibly!
Read the manual before use and keep it in a safe place for future use and maintenance.
Garantie bezoek www.elro.eu
ELRO Europe | www.elro.eu
Postbus 9607 - Box E800
1006 GC Amsterdam - The Netherlands