Erreka MAXI Operating instructions

9
MAXI
Quick installation and programming guide English
WARNING
This quick guide is a summary of the complete installation manual. The manual contains safety warnings and
other explanations which must be taken into account. The installation manual can be downloaded by going
to the "Downloads" section of Erreka website:
http://www.erreka-automation.com
I277B
Elements of the complete installation
Electrical wiring
A: Main power supply
B: Closing photocells
C: Pushbutton / wall key
D: LUMI flashing light
E: Operator (motor / encoder)
Assembly levels
Level H: the track should remain 10 cm above the
highest point of the door (see detail H ).
Total length (operator + guide) / working stroke:
– track ref. AMX01: 3,380mm / 2,788mm
– track ref. AMX02: 4,480mm / 3,888mm
MSP-030/00

10
Unlocking and locking
Unlocking
Unlocking for manual operation
Pull the knob or cable (1) until the release lever (2) is
vertical.
Locking
Motorised operation locking
Place the lever in horizontal position (3). Locking will take
place when the operator starts up.
D277C
D277D
3
P277A
P260B
3
4
Assembly
1
Secure the track (1) in the operator (2).
2
Position the overhead strips (3) and front support (4).
Bear in mind assembly level H(see “assembly levels”
on the previous page).

11
P277G
P277F
6
Install the central mount (9).
7
Open the door and install the opening stopper
(10) until it comes up against the carriage (11).
Use two self-drilling, self-tapping screws.
P260D
5
5
6
7
8
P260E
4
Position the anchoring (5) in the upper part of the door using the arms
(6) and (7), and couple it to the carriage (8).
5
Tighten the nut as far as possible,
and then loosen it slightly until the
sleeve can be turned by hand.
P277C
3
Mount the track (1) + operator (2) on the supports (3) and (4).
OThe track (1) must be horizontal.
P277H
8
Close the door and install the closing stopper
(12) until it comes up against the carriage (11).
Use two self-drilling, self-tapping screws.

12
P277Z
MAXI
MXS120
Electrical connections (panel VIVO-D102)
A.T. Wall key or pushbutton
SG.C Closing safety device
(closing photocell:)
SG.A Opening safety device
(opening photocell:)
FT Connection for photocells with testing
AUX Power supply for peripherals (24 Vdc)
STOP Not used, perform bridging
DEST Flashing light (LUMI)
LG Garage lights
G1 Blue (motor)
G2 Red (motor)
P14 (GND) Mesh (encoder mesh) (–)
P15 (SNG1) Green (encoder signal) (S)
P13 (V+) Brown (encoder power supply) (+)
Disconnect the power supply before connecting or disconnecting any component.
The A.T., S and STOP devices must be voltage-free in order to prevent any damage to the control board.
(max. 2300W)