fantastic furniture GECKO User manual

GECKO
Bed Single
Assembly Instructions
Ver1.2

Page 2
2
3
56
Read Instructions carefully.
Lay out all of the components on a soft surface
as if you were preparing to do a jigsaw puzzle.
Carefully identify each component, especially
those that are similar. The most common mistake
is getting things back to front.
Separate and identify each component from the
hardware pack and rest each one in its proper
W
A
R
N
N
G
WARNING
Check no parts are missing.
4
fully tighten screws（leave slightly
loose.When the item is fully assembled
tighten the screws - but do not over tighten.
FAILURE TO FOLLOW THESE BASIC STEPS CAN LEAD TO DAMAGE
THAT IS NOT COVERED BY YOUR WARRANTY
If glue is required DO NOT set until you are
certain that the parts belong together.

What you Need
To Assemble the Body
Please make sure you have all these parts before you start.
Allen key provided
8 x Bolts
(H1)
13 x Fantastic Furniture
ComfortSlatsTM Single (P5)
26 x Plastic Connectors
（P4）
Page 3
Bed Foot
(P2)
2 x Side Rails
(P3)
Bed Head
(P1)

Bed Head
(H1)
(H1)
(P1)
(H1)
(H1)
Bed Foot
(P2)
Step 1
You will need
4 x Bolts
(H1)
Step 2
You will need
1 x Bolts
(H1)
5mm
Insert 4 x Bolts (H1) into the lower holes in Bed Head (P1) and Bed Foot (P2) using
Allen Key provided. Do not fully tighten Bolts.
1.
2.
Attach one Side Rail (P3) to the Bed Head (P1) with Bolt (H1) and fasten tightly.
1 x Allen key
1 x Allen key
（P3）
(H1)
Page 4
(H1)

Step 3
You will need
1 x Bolts
(H1)
1 x Allen key
1.
2.
(H1)
(P2)
(H1)
Attach Side Rail to Bed Foot (P2) with Bolt (H1) in the upper hole. Leave bolt loose.
Step 4
You will need
2 x Bolts
(H1)
1 x Allen key
Attach the other Side Rail (P3) to Bed Head and Bed Foot with 2 x Bolts (H1) in the upper holes.
Leave bolts loose.
(H1)
Step 5
You will need:
26 x Plastic
Connectors
(P4)
Push 26 x Plastic Connectors (P4) firmly onto
Page 5
（P3）
13 x Fantastic Furniture
ComfortSlatsTM Single
(P5)
13 x Fantastic Furniture ComfortSlatsTM Single (P5).

Repeat for every bed slat until finished.
IMPORTANT: Fully tighten all bolts on bed.
Place the slat in position then push down on
the centre of the slat to flatten out the slat.
Make sure the plastic prong lines up with the hole.
Then push firmly
Repeat the same process
for the other end of the slat.
Step 6a
Step 7
Step 8
Step 6b
Page 6
1 x Allen key