Glow Bricks GHOSTBUSTERS ECTO-1 Lego 10274 User manual

1

2
First of all, remove the headlights and the clear round plates on frog lights
For the red circle area, leave one round plate on each side
Take the following lighting part ready

3
Install the lighting parts, remove the tiles to put the wires in between the studs
Restore the tiles, for the connector put it through the hole

4
Remove the siren lights and take the following lighting part (the grey bottom one
with 3blue 2x2 round plates)
Remove the parts from the original parts and move them to the light

Install the lights on the top first, make sure the direction of connector is correct
5
Take the slope away to pull the blue round plate to the side mirror position

Install the lights, pull the wire down to the same place as the previous part
6
Take the following lighting part, remove the original part from the model

Restore the parts removed, the connectors are place inside the car
7
Take this lighting parts to install inside the car

8
Install the grey plate above the drive seat
Then install the rest black plates at the back
*If you feel difficult to install you may remove the top of the car

9
Now it’s turn for the rear lights, take the rear bumper out, detach as shown
Remove the clear red parts from the car and leave the 1x1 plates
Combine the lighting parts with the grey parts, pass the lighting cones
through the holes

10
Restore the parts to the plate, split the bricks as shown
Then put the wire in between the studs of the plate
Put one side of the brick on and arrange the wire for other side

11
Then restore the other brick
Now remove the back door the install the black lighting plate

12
Put the wire in between 2joints for the door
Then install the black plate

13
Take the blue siren lights off, remove the parts to put on the lighting parts
Install the siren light first, lift the white part in middle to hide the wire underneath

14
For the connector, pull it inside the car through here
Now collect 3connectors to the back to connect with power

15
Connect by battery case, place it as shown
Connect by USB, pull it through the bottom

16
For the connectors at front, the battery case can be place under the seat
For the USB cable, can clip the wire by the slope