Glow Bricks Lego Lamborghini Sian FKP 37 42115 User manual

Lamborghini SiánFKP 37
1

2
Before installing the lights, remove the two headlights from the vehicle

They can be removed by detaching the part in red circles
Prepare the following lighting parts
3

To install the leds on headlights, start by pulling the bar off abit as shown
Then combine with the led plate
4
Put the white tubes in to cover lighting bars as shown

Install one of them first
5
Then store the bar and push the tube to totally cover the lights

Then another light
6

Then another light
7

Then install the lights for other side
Do the same steps as before
8

Now the headlights are installed
9

Then restore the headlight
Guide the connector to the hole to middle of car
10

Then leave it beside the seat
Ready the following light, pile the white tape away and stick it above the seats
11

12
Install the lighting round plates to bottom of the car

13
Now it’s turn for rear lights, detach the following parts and split as shown

14
Install the lighting parts, then restore the parts detached

15
Then install for the other side

16
Restore the rear lights, and install two lighting round plates

17
Pull the 2connectors inside the car through the hole in red circle

18
Now you have 5connectors inside the car, connect with USB cable

19
Hide the connectors under the seat, pull of the USB cable
If powered by battery, the battery case can be placed on the seat