Glow Bricks Lego TRANS FORMERS OPTIMUS PRIME User manual

1

2
First, take out the 2plates at the bottom of the power cube and replace by the
shown lighting parts

Start by replacing the 2x2 round plate in the red circle by the lighting part
3
Then take the orange lighting parts for the axe

Then replace the 2x4 plates by the lighting plate on the top
4
Then put the bricks back on the plate

5
Place the remain lighting plate to the shown spot to replace the 1x6
For the 1x2 plate and the round plate next to the previous lighting plate, assemble
them to the arch shown

Take the shown lighting parts for the feet
6
Now the axe is ready

7
Turn the Prime around, take the shown lighting parts for the boosters

8

Remove all the parts in the red circles
9
Get the remain lighting parts to assemble on the chest

Then assemble the grey lighting parts on the other side, remove the tiles in
between to hide the cables in between the studs
10
Start from the grey lighting parts, remove the shown red part in purpose to move
the remain lights behind

At last connect with the USB cable and it’s done
11
Then put the round tiles from the original plates on the lights

For the cable it could be hidden under the tile as shown
12
Pull the remain lights to the chest area and assemble the yellow round plates first

The cable to the connector would be get through by the gap of the window
13
Put the Matrix back to the chest and assemble the orange lighting plate on it

Now you should have 3connectors at the back
14
Stabilize the cable by the backpack

You can still transform to the truck with the lights assembled
15
Now you can light up the model by connecting the USB cable
The power cube and the axe would be optional

16
Just follow the instruction to do the transformation, pull the connectors to the back
and connect the USB cable again