Glow Bricks Lego Technic Fast & Furious Dom's Dodge... User manual

Dom’s Dodge
1

2
For the rear part of the car, remove the brake light and the pipes,
leave the following parts and prepare this lighting parts

Install the lighting brake lights and pull the wire through to bottom
Assemble the lighting parts into the pipe
3

Prepare following lighting parts for the middle of the car
4
Put the pipes back to the position and beware of the wires when assembling
Leave the connectors and deal with that later

Install the 1x4 lighting plate at the following position and pull the connector to bottom
5
Now remove the following part to assemble with this lighting part

Remove 3grey round parts and push the leds into the red hole
(Be sure it’s deep enough)
Then restore the parts
6

Now for the front, remove the grey barrier and the trans orange tile to combine with
the lights
Remove the round plates from the headlights, assemble with the lighting parts
And please follow the layout of the lights,
7

8
Install orange light on right side, connect the extend cable and connect each other

9
Then install the head lights
Now you can make it look better by hiding the cables, for separate the connector from
last step, pass one side of it behind the bumper and reconnect it

10
The other connector can be hidden in here
Restore the grey barrier then the assembling is finished

11
To power up by USB, arrange all the connectors to the bottom of the car as shown

12
To connect by battery case, pull all the plugs to the co-pilot seat position
Find out the connector for the lights in red circle and connect with the separate battery
case and connect the rest 5connectors with the big battery case

13
After that hide the cases to the position as shown