Glow Bricks Lego Home Alone 21330 User manual

1

2
Start by assembling lights for the van, take the following lighting parts
Replace the grey plate by the lights

Assemble it to the top
3
After assembling the clear parts, restore the front light and pull the remain lights
to the back

Replace the 1x6 plate on the back by the lighting plate
4
Pull the connectors inside the car and connect with the battery case

5
Take the lighting parts shown for the tree house
Start by assembling the 1x3 white plate inside the house

Separate the back door part and assemble by this lighting parts
6
Then assemble the lighting round plates on the leaves randomly

Restore the lamps of the house and replace the fire
7
Separate by the layers, detach the shown part, replace the clear yellow round bricks
by the lighting parts

Pull the remain black lighting plate to the bottom and assemble it
8
Assemble the 1x8 lighting plate as ceiling light

Take the following lighting parts for the front door lights
9

For the light bulb at the end, assemble it inside the head
10
Replace the yellow round plates by the lighting round plates

Then restore the middle room and the top level
11
Restore the lights on the front door

Start from the lights next to the connector and assemble from the bottom of the
tree
12
Now take this lighting parts for the x’mas tree

It can be done very randomly, just make sure the last four round plates are
assembled on the top layer
13
Replace the round plates on the tree by the lighting parts layer by layer

For the poles, install the lighting round plates right under the dishes on top of it
14
Take the tan lighting plates to assemble it underneath the 2nd floor as shown

15
Connect with the x’mas tree by the connector on the left side
Restore the tree and combine the 1st 2nd floor

Take the last lighting parts for the roof
16
The connector with shorter cable pull it to the upper floor
And the other one will be pulled to the back of the house

Pull the remain lightings to the bottom
17
Start by assembling the white lighting plates and the round plate to the lamp

Connect the cables with the 2nd floor
18
Assemble them to the bottom as shown

19
Combine the building and connect all four connectors to the USB cable