Glow Bricks Apollo 11 Lunar Lander Lego 10266 User manual

1

Part A Part B
Start from Part A
Remove 2grey arches from the top and separate front and rear big parts as shown
2

Plug the 2pcs of 1x2 grey parts onto the position
Install 4grey round plates on both arms
Pass 3parts through the body
3

Install the 1x4 grey part onto the ceiling
Pass the wire to the top and install 2grey arches
(can clip the wires like the way shown in red circle below)
Install 4grey round plates to both arms
and hide wire under the 22x4 tiles in the middle
4

Part A finished
Now it’s Part B’s turn
(The side with “United States is the front and we’ll put the usb plug close to the rear side)
Turn the model upside down and the rear side face to you
5

Install the first 1x4 from the usb plug as the picture shown
Install all 41x4’s
Pass 41x1 lights parts from the bottom thru the middle space
6

Install the all 4of the 1x1 light parts
Install the top part and pass the connecting wire thru the middle space
Connect the wire plugs of Part Aand B
7

8