Glow Bricks Lego Harry Potter Chamber of Secrets 76389 User manual

Chamber of
Secrets
1

2
Take the lighting part shown for this building

First of all split the building as shown, remove all the clear green round bricks
Start from assembling the end light to the bottom corner
3

Then replace the fire by the lighting parts
4
Then assemble the second one and third one

Then assemble the forth one
5
Now assemble the 1x2 grey lighting plate and the green lighting brick with longer
wire at the bottom

After install all the green bricks, put the top back to the position
Then assemble the remain 1x2 and round plate as shown
6

Take the following lights for this side of the house
Start by splitting the building like this
7

Assemble the lighting plates exactly as shown
After that take the fire place at bottom and replace the fire
8

Pull the remain lights to upstairs by the gap and beware the wire has to be in between
the studs
Assemble the 4 pcs of lighting fire in the fireplace first
9

Open the brown triangle plate, assemble the brown plate and the fire
After that take the two connected fires to the candles
10

The remain single fire will be assembled at the front side
Do the same procedure for the other side
11

Replace the blue and purple diamond by the lights
Move the last 2 lights to the middle and stick them as shown
12

Before assembling the light, split up this building first
Start by assembling the grey lighting plate which is next to the connector
13

Move the remain lights to upstairs by this gap, beware has to be in between studs
Assemble the diamond and the fires to candles
14

Take the upstair parts and assemble the tan lighting plate
Take the lighting clear round plate out and install it on the clear pole
15

Restore the top and place the wire in between the studs
Assemble the green lights to the scope
16

At last stick the light to the top, this side of building will be done
Finally, connect three connectors to the USB cable to light it up
17