Glow Bricks Land Rover Defender Lego 42110 User manual

1

Start with the rear light part first
2
Take the red square plates with white round plate away

Install the black round plate lighting part as shown
Hide the wires connecting the black round plate underneath the grey part
3
Install the red lighting parts

For the other side of the light with connector plug, remove the parts shown
in purpose to pull the wires to the front
Install the lighting parts and adjust the wire to the front
4

Restore the green parts after the wires moved under the driver’s seat
Now it’s turn for the interior lights
5

The white plate lighting part should be installed on rear seats side and black lighting parts
on front seats side
6

Adjust the connectors of 2previous parts together
7
You need to move both of the connector plugs to the engine area, and there’s
ahole in the red circle below to get them through

Get the plugs on engine then we can go to the next step
Take the front lights away, separate the black dishes to assemble with the lighting part
8

The lighting black round plate will be installed on the side of the vehicle
9
Remove the green parts as shown to move the front lights to the front

Adjust the wires to the front and remember don’t let them stuck to the wheel to
interrupt when they’re spinning
Now you can install the front lights
10

11
Restore the green part after the light is installed
Repeat the previous step on the other side

This is how to connect by USB cable
12
Now you can connect to the power, you can choose either battery case or USB cable
Can put the battery case as shown