Glow Bricks HarryPotter 4 Privet Drive Lego 75968 User manual

4Privet Drive
1

2
Start by installing car lights
First of all detach the two bricks and remove the clear yellow tiles

Install the tiles to lighting bricks, put them back to the head light position
Then place the wire in between the white studs
Restore the 1x6 blue plate and the slope, watch out don’t break the wire
3

Replace the following lights to the rear lights position
4
Pull the remain lights to the back of the car, and detach the parts shown

Restore the parts removed from previous steps, move the lighting
plate to the middle
5
Then install then as shown

Before closing the top, connect with the battery case
Or connect with the USB cable
6

Now it’s turn for the house
Take the cone with shorter cable to replace the lighting on the front door
7

For the 1x4 grey lighting plate next to the cone, install it on top of the door
The 1x4 tan lighting plate next to the grey plate install it to indoor area
8

Tap up the plate in red circle, place the wire in between the studs
Install the 1x4 tan lighting plate in red circle area, then remove the picture, place the
cable in between the studs then restore the picture
9

Then pull the remain two lighting plates to 2nd floor and install them on ceiling
For the other lighting cone, move it to the room under the stairs
10

Remove the shown parts, place the wire in between the studs
and replace the lamp
11