Glow Bricks Lego Harry Potter Hogwarts Astronomy Tower... User manual

Hogwarts Astronomy
Tower
1

2
Start by splitting the building
Then take the following lighting parts for this side of the house

Detach the top of the front side as shown
Replace the clear block of the house by the lighting part
Stick the light underneath the arch
3

Restore the top, then assemble the fires on candle and the clear lighting parts on table
4
Combine the parts of the previous step, assemble the 1x2 ligthing plates on both sides
Make sure to follow the direction as shown

Remove the top of the attached building, stick the remain lighting
parts to the top
5
Now you may put the roof back and restore the building

Now it’s turn for the other side
Same as the previous side, split the building as shown
6

Assemble the 1x4 plate next to the connect to underneath the 2nd floor
Then remove the pole in purpose to pull the remain lights upward
After that restore the pole, install the two lighting clear round plates to the candle
7

Before combining the 2nd floor with the 1st,clip the wire in between the studs of the
block attached to prevent it got broken
Put the rest of the building to the top and push the 1x4 plate into the ceiling
8

Pull the lights into the building by removing pole, the similar way as downstairs
Install the 1x6 as ceiling light and the fire to candle
Then assemble the 1x4 lighting plate and the white lighting tile
9

At last, stick the 1x1 lighting tile and install the lighting diamonds
Connect with the USB cable and that’s all~
10