Glow Bricks Lego Volkswagen T2 Camper Van 10279 User manual

1

2
Take the lighting parts at the bottom of the picture
And detach the front part of the car as shown

3
Install the lighting parts on the plate, and place the clear orange tiles on the lights
Place the clear orange slope on the lights of blue plate, then restore the bumper like
this

4
Recorp the upper bumper with the car, also the parts of the side
Restore the parts of previous step and the front car light

Restore the upper part, to restore the 2x4 tiles you need to stable the wires in
between the studs to avoid breaking the wires when restoring the tiles
5

Then the front part lighting installation is done
6
Place the connector to the bottom of the car

Now take this lighting part for the top
7
Install it as shown
Beware of the position of the fire

8
Now it’s turn for the rear side, detach the following parts
Replace the grey part by the lighting parts

9
Before restoring the parts, need to pull the connector to the bottom by getting
through the hole
Then you can restore the rear side

10
Place the front top on the car first
To place to the male connector to the bottom, remove the slope on the edge, stable
the wire in between the studs then restore the slope

11
Now connect the connector of the remain top as well the fire on the stove
Then restore the top, and remember to check does the top able to flip up

12
Place three connectors to bottom, stable the wires by the plates provided

13
Now you can choose to power by battery or USB