IHP CHAROAK35 User manual

1
CHARRED OAK AND DRIFTWOOD LOG SETS
P/N 900796-00
Rev. NC, 09/2016
HEARTH PRODUCTS
KITS AND ACCESSORIES
KIT CONTENTS
1 ea. Log Set
1 ea. Instruction Sheet
TOOLS NEEDED
None
INSTALLATION INSTRUCTIONS FOR INSTALLING DRIFTWOOD AND CHARRED OAK* LOG SETS FOR USE WITH
SCORPIO AND DRT3500 SERIES DIRECT-VENT GAS FIREPLACES
GENERAL INFORMATION
This log placement guide has been prepared to present detailed log
placement illustrations and provide instruction to assist in the placement
of logs at the initial (new appliance) setup and after the annual cleaning
and inspection cycles. The information provided here is to be used in
conjunction with the Installation and Operation Instructions provided
with the appliance.
If you encounter any problems, need clarification of these instructions or
are not qualified to properly install this kit, contact your local distributor
or dealer.
Read this instruction sheet in its entirety before beginning the installation.
DO NOT attempt to install the logs until the appliance installation has
been completed, the gas line connected and tested for leaks and the
initial burner operation has been checked out.
The logs have notches/tabs to assist proper positioning. Upper logs rest
on lower logs via notches/tabs. Proper log placement is critical to prevent
sooting. Place the logs in the gaps between flame peaks, so they do not
impinge the flames. Follow the log placement instructions precisely.
ALL WARNINGS AND PRECAUTIONS IN THE INSTALLATION AND
OPERATION MANUAL PROVIDED WITH THE APPLIANCE APPLY TO
THESE INSTRUCTIONS.
SHUT DOWN THE APPLIANCE AND ALLOW IT TO COMPLETELY COOL
BEFORE PROCEEDING.
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
Figure 1
Log Sets - Traditional Models *
Cat. No. Model Description
F2876 CHAROAK35 35” Charred Oak Log Set
F2877 CHAROAK40-45 40” and 45” Charred Oak Log Set
F2878 DFTWOOD35 35” Driftwood Log Set
F2879 DFTWOOD40-45 40” and 45” Driftwood Log Set
Table 1
INSTALLATION INSTRUCTIONS - 35/40/45 DRIFTWOOD LOG SET
(Scorpio series only)
Figure 2 - Locate the log placement tabs
Log Location Tabs
Place Glowing Embers
Tab for
Log #2
Tab for
Log #1 Tab for
Log #2
1. If necessary, remove the glass door per instructions in the
Installation and Operation Manual. Locate the placement tabs
(Figure 2).
2. Bend up the log placement tabs (Figure 2). Place glowing embers
and other media (see Figure 2).
1
35
4
2
6
Log Number Description
1 Left Rear Log
2 Rear Log
3 Left Top Log
4 Right Bottom Log
5 Right Top Log
6 Front Ember Log
* DRT3500 Series fireplaces are approved for use with the Charred Oak Log Sets only.
fire-parts.com

2
Figure 3 - Place log #1
3. Align the notches in the left rear log (1) with the left rear locating tab
(Figures 2 and 3).
4. Position the Rear Log (2) on the left front and right rear log
placement locating tabs (Figures 2 and 4).
5. Position the left top log (3), shown in Figure 5 on locating pins
outlined in Figure 4.
Figure 4 - Place log #2
Figure 5 - Place log #3
1
Pin for
Log #3
3
4th Log will be placed
on the corner of grate.
2
Pins for
Log #3
6. Position the right bottom log (4) on the corner of the grate (Figure 5)
and as shown in Figure 6.
7. Position the right top log (5) on the pin shown in Figure 6 and as shown
in Figure 7.
Figure 6 - Place log 4
4
Pin for
Log #5
5
6th Log will be placed on the grate
Figure 7 - Place log 5
8. Position the front ember log (6) on the grate called out in Figure
7and as shown in Figure 8.
6
Figure 8 - Place log #6
fire-parts.com

3
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
Figure 9 - 35 Charred Oak Log Set
INSTALLATION INSTRUCTIONS - 35 CHARRED OAK LOG SET
3
4
2
1
Log Number Description
1 Left Rear Log
2 Rear Log
3 Top Front Right Log
4 Top Front Left Log
1. If necessary, remove the glass door per instructions in the
Installation and Operation Manual. Locate the placement tabs
(Figure 10).
2. Bend up the log placement tabs (Figure 10). Place glowing embers
(see Figure 10).
3. Align the notches in the left rear log (1) with the left rear locating
tab (Figures 10 and 11).
Figure 10 - Locate the log placement tabs, 35”
Figure 12 - Place log #2
Figure 11 - Place log #1
Figure 13 - Place log #3
4. Position the Rear Log (2) on the left front and right rear placement
locating tabs (Figures 10 and 12).
5. Position the top front right log (3), as shown in Figure 13 on the
locating pin outlined in Figure 12.
Place Glowing Embers
Tab for
Log #1
Tab for
Log #2
Log Location Tabs
Tab for
Log #2
1
2
Pin for
Log #3
3
Landing area for Log #4
35” Models
fire-parts.com

4NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
6. Position the Top Front Left Log (4), shown in Figure 14 on the
landing area outlined in Figure 13.
Figure 14 - Place log #4
Figure 15 - 40/45 Charred Oak Log Set
4
INSTALLATION INSTRUCTIONS - 40/45 CHARRED OAK LOG SET
3
2
5
4
1
Log Number Description
1 Left Rear Log
2 Rear Log
3 Front Right Log
4 Top Front Right Log
5 Top Front Left Log
3. Align the notches in the left rear log (1) with the left rear locating
tab (Figures 16 and 17).
4. Position the Rear Log (2) on the left front and right rear placement
locating tabs (Figures 16 and 18).
Figure 16B - Locate log placement tabs, 45”
Figure 1 - Locate log placement tabs, 40”
Figure 16A
1. If necessary, remove the glass door per instructions in the
Installation and Operation manual. Locate the placement tabs
(Figure 16A or 16B).
2. Bend up the log placement tabs (Figure 16A or 16B). Place glowing
embers and other media (Figure 16A).
Tab for
Log #1 Tab for
Log #2
Tab for
Log #2
40” Models
45” Models
Tab for
Log #1
Tab for
Log #2
Tab for
Log #2 Tab for
Log #3
fire-parts.com

5
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
Figure 17 - Place log #1
Figure 18 - Place log #2
1
2
5
Figure 19 - Place log #3
5. 40” Models - The front right log (3) butts up against the grate as
shown in Figures 19.
45” Models - Align the notch on the bottom of the front right log
(3) over the front right locating tab. See Figures 16 and 19.
6. Position the top front right log (4), as shown in Figure 20 on the
landing outlined in Figure 19.
Figure 20 - Place log #4
4
Pin for Log #5
3
Landing for Log #4
Figure 21 - Place log #5
7. Position the Top Front Left Log (5), shown in Figure 21 on the pin
outlined in Figure 20.
fire-parts.com

6
Printed in U.S.A. © 2016 Innovative Hearth Products
P/N 900796-00 Rev. NC 09/2016
IHP reserves the right to make changes at any time, without notice, in design, materials,
specifications, prices and also to discontinue colors, styles and products. Consult your local
distributor for fireplace code information.
1508 Elm Hill Pike, Suite 108 • Nashville, TN 37210
fire-parts.com