Lionelo Hugo User manual

Hugo
Baby car seat
Fotelik samochodowy
Kindersitz
Детское автокресло
Seggiolino auto
Siège auto bébé
Silla de coche
Autostoeltje
Kūdikio automobilinė kėdutė
Dětská autosedačka
Baba autósülés
Scaun auto pentru bebeluși
www.lionelo.com
Manual de usuario
Handleiding
Naudojimo instrukcija
Návod k obsluze
Használa utasítás
Manual u lizare
User manual
Instrukcja obsługi
Bedienungsanleitung
Инструкция по эксплуатации
Manuale d’uso
Manuel de l’U lisateur

‑ 2 ‑
2
1
3
67
A B
C
1
4
5
7
6
8
9
2
3
5
4

‑ 3 ‑
8
A
D E
B C
109
11 12
1
2
3

‑ 4 ‑
13
14

‑ 5 ‑ EN
EN
INFORMATION
When using for groups II, III, „universal” category:
A holding device intended for children has been categorized as an „all-purpose”
device. It has been granted a cercate of approval in accordance with the
regulaons no. 44, amendments series 04, for general use in vehicles and is t
for assembly on most car seats.
The device can be installed properly if the vehicle manufacturer has specied
in the vehicle manual that this vehicle is suitable for installaon of the holding
device for this weight group.
This child restraint has been classied as ‘universal’ under more demanding
condions in relaon to condions applying to earlier designs that do not bear
this informaon.
If in doubt, consult the device manufacturer or retailer.
When using for groups II, III, „semi-universal” category”:
This child restraint system has been classied for use in „semi-universal” categories
and is t for installaon on seats in the following cars:
CAR FRONT OUTER REAR MIDDLE
(model) YES YES NO
The model list is at the end of the user manual.
This device may be t for installaon also on seats of other car models. In case of
any doubts, please consult the manufacturer or retailer of the device.
Suitable for installaon only if type-approved vehicles are equipped with
three-point safety belts that have been approved in accordance with UN / ECE
Regulaon No. 16 or other equivalent standards.
This is an ISOFIX CHILD RESTRAINT SYSTEM. It is approved in accordance with
Regulaon No. 44, 04 series of amendments, for general use on vehicles equipped
with ISOFIX anchoring systems.

‑ 6 ‑EN
It ts vehicles with posions approved as ISOFIX posions (according to the vehicle’s
operang instrucons) depending on the child seat category and aachment.
The age group for which the device is intended: II, III.
Dear Customer!
In case of any quesons or comments on the purchased product, please contact
us: [email protected]
Before using this seat, please read the user manual carefully. Improper use may
lead to a serious threat to the life of your child.
The product is authorized for ECE R44/004 as the safety seat for weight groups
II + III (15 - 36kg).
The product must always be used and installed in accordance with descripon in
this manual. A failure to follow the manual may lead to accidents.
Producer:
BrandLine Group Sp. z o. o.
ul. A. Kręglewskiego 1, 61-248 Poznań, Poland
Important
Please read this manual before you start using the product and keep it for future
reference. The manual will help you secure the safety seat properly. An unsuitable
assembly may pose a threat to your child. The manufacturer shall not be held
responsible for potenal danger arising from unsuitable assembly.
1.
This safety seat is intended for weight groups II-III, which means that it
applies to children from 15 to 36 kg of weight (aged 4-11).
II weight group: 15kg-25kg
III weight group: 22kg-36kg
2.
If in doubt regarding mounng, contact the manufacturer of the restraint
system.
3. Do not install any addional elements to the device without the consent of
the competent authories.
4. Do not use load bearing points of contact other than those described in the
instrucons and marked on the child restraint.

‑ 7 ‑ EN
5. For installaon with ISOFIX, refer to the vehicle’s instrucon manual.
6.
The safety seat is intended for vehicles equipped with 3-point seatbelts
which have been granted the cercate of approval in accordance with the
regulaons no. 15 ECG/UN or other equivalent standards.
7. Any belts which x the safety seat must be tense, adapted to child’s body
and must not be twisted.
8. All hip straps must be posioned low so that the child’s pelvis is held rmly.
9. Do up buckles properly and securely. In case of emergency, a child can be
easily taken out of the seat thanks to proper installaon of buckles.
10.
Please replace the device if it has been subject to considerable loads in
the accident.
11. Do not modify this product in any way.
12.
Avoid situaons in which the safety seat is exposed to direct sunlight.
Otherwise it may reach high temperature and in eect scald the child.
13. Do not leave the child in the safety seat unaended.
14. Make sure the luggage and other items which may injure the body in case
of accident have been secured properly.
15. Do not use the safety seat without its cover. Do not replace the cover with
other not recommended by the manufacturer. The cover is an integral part
of the child’s safety seat.
16. The safety seat may be used in the car only.
17. It is forbidden to place any items on the child’s safety seat.
18. Hard elements and plasc parts of the holding device must be placed and
installed in a way that are not trapped due to sliding seat or vehicle door
during regular operaon.
19.
Before every travel, make sure the safety seat has been secured properly
and rmly.
20. When driving, the safety seat must be rmly aached to the vehicle seat by
means of the seatbelt, even if there is no child.
CAUTION!
Never use the safety seat with 2-point seatbelts (g. 1).

‑ 8 ‑EN
Safety seat outline (g. 2)
1. Headrest
2. Backrest
3. Seat
4. Seatbelt handle
5. Seatbelt guide
6. Height adjustment handle
7. Backrest hinge
8. ISOFIX xing arm
9. Bole holder
How to x backrest
1. Place the backrest horizontally behind the seat, put the hinge on the seat
connector (g. 3A).
2. Straighten the backrest so that the hinge is inserted in the seat connector
(g. 3B).
3. Straighten the backrest completely (g. 3C).
NOTE: When assembling the backrest, make sure there is nothing between
the backrest and seat. Watch your ngers during assembly.
How to adjust headrest
NOTE: Do not use the safety seat if it has not been secured in the car. Place the
child in the safety seat once you have nished assembly.
Thanks to a properly secured headrest, the seatbelt is properly posioned and
your child is provided with comfort and safety.
The headrest can be adjusted in eleven posions. The headrest height must be
adjusted in a way that two ngers t between child’s arms and headrest (g. 4).
To set the headrest height (g. 5):
1. Grab the handle behind the headrest and pull upwards gently.
2.
Adjust a suitable headrest height. When you release the handle, the headrest
will lock in posion.
3. Place the safety seat in the car.
4. Check the headrest for proper height when the child is in the safety seat. If
the height is wrong, repeat the procedure.

‑ 9 ‑ EN
How to assemble safety seat
Assembly with seatbelt
1. Fastening seatbelts
• Place the safety seat on the car seat. Make sure the safety seat backrest ts
ght to the seat backrest (g. 7).
• Place the child in the safety seat.
• Pull the seatbelt, carry in front of the child and fasten it (8a).
2. Placing seatbelt in the safety seat handle
• From the seatbelt fastening side - carry the hip part through the red indicator
under the elbow rest (8a, 8e).
• The arm part must be carried above the elbow rest.
• On the other side – carry the hip part through the red indicator under the
elbow rest (8c).
• Remember that the hip part of the seatbelt must be carried as low of the
child’s hips as possible.
•
Carry the arm part of the seatbelt through the red handle in the headrest (8d).
• Make sure the arm part of the seatbelt goes through the collarbone, instead
of neck.
Assembly with ISOFIX system
1. Press buon on ISOFIX xing arm and pull it out as far as you can (g. 9).
2. Slip the safety seat in ISOFIX xing in the car unl you can hear clicks on
both sides. There should be a green buon on the arm (g. 10).
3.
Make sure the safety seat has been secured properly. If it scks out or moves,
repeat the assembly (g. 11).
Once you have assembled the seat, make sure that the safety seat has been
secured properly again:
1. Hip part of the seatbelt must go through red indicators under elbow rests
on the seat (g. 12-1).
2. Arm part goes above the elbow rest from the belt fastening side (g. 12-2).
3. Arm part of the belt goes through the handle under the headrest (g. 12-3).
4. Seatbelts are tense and must not be twisted.
5. Seatbelt fastening is not under the elbow rest (g. 13).

‑ 10 ‑
Cleaning and maintenance
Use the safety seat along with the seat cover only. To disassemble the backrest,
put the backrest down and pull upwards to detach it from the seat (g. 6).
1. To remove the cover, unzip the back of the safety seat (g. 14).
2. You can remove and wash the cover with a mild detergent in a so fabric
mode and at the temperature of 30°C.
3. Do not spin or dry in the drum drier.
4. You can use a wet cloth to clean plasc elements of the safety seat. Do not
use strong detergents.
The pictures are for reference only. The real design of the products may dier from the
pictures presented.
PL
INFORMACJA
Przy użytkowaniu dla grup II, III, kategoria „uniwersalne”:
Urządzenie przytrzymujące dla dzieci należy do kategorii „uniwersalne”. Uzyskało
homologację zgodnie z regulaminem nr 44, seria poprawek 04, do ogólnego
zastosowania w pojazdach i nadaje się do instalacji na większości miejsc siedzących
w samochodzie.
Prawidłowa instalacja jest możliwa, jeśli producent pojazdu oświadczył w instrukcji
obsługi pojazdu, że pojazd ten nadaje się do instalacji urządzenia przytrzymującego
dla tej grupy wagowej.
To urządzenie przytrzymujące dla dzieci zostało zaklasykowane do kategorii
„uniwersalne” w bardziej wymagających warunkach w odniesieniu do warunków
stosujących się do wcześniejszych projektów, które nie są opatrzone tą informacją.
W przypadku wątpliwości należy skonsultować się z producentem lub sprzedawcą
detalicznym urządzenia.
Przy użytkowaniu dla grup II, III, kategoria „półuniwersalne”:
To urządzenie przytrzymujące dla dzieci zostało zaklasykowane do użycia w
EN | PL