7
Operation
Use with power adapter
• Connect the adapter jack into the
adapter jack connecter.
• Connect the power adapter plug to the
electrical outlet. Turn on the main switch.
• When the product is operating while
connected to power adapter, uMoby
Smart will not be charging.
Use without power adapter
• Product must be fully charged prior to
using it for the first time.
• The red LED indicator beside [ ] button
will blink while it is charging. Once fully
charged, it will lit on.
• uMoby Smart only can be charged when
product is Off.
• Each full change (approximately 3 hours)
lasts up to 60 minutes of usage(Usage
time varies based on the program
selected).
• Do not exert excessive pressure on
the uMoby Smart. This may cause
significantly overheating and subsequent
damage to the product.
• Do not attempt to stop the kneading
massage nodes with your hand.
Turning the power on/off
• Please ensure the control panel is placed
on your left side when using the product.
• Press the [ ] button to turn on the
uMoby Smart and the green LED
indicator will light up.
• When the app is not connected to the
uMoby Smart, the product will turn off
automatically after approximately 4
minutes of inactivity.
• Press the [ ] button once when no
massage program is running and the
green LED indicator will be off.
Massage program selection
• Press the [ ] to power on the uMoby
Smart.
• Press the [ ] button once and the
massage will begin at ‘Deep Tissue’. The
corresponding red LED indicator will light
up.
• Press the [ ] button to cycle through
the 2 auto massage programs.
I. Deep Tissue (default with heat
function and the red LED will
remain lit during the 15-minute
massage).
II. Relax (default without heat
function and the red LED remain
lit during the 15-minute massage).
• Press the [ ] button once to stop
massage program. The corresponding
red LED indicator of massage program
will be off.
• The heat function for the auto massage
can be turned on or off using the app.
• The manual massage program is
available on the app.
Note
