PNI A014 User manual

RO
Introducere
Sirena de interior PNI A014 poate fi utilizata impreuna cu un sistem de
alarma la efractie montat acasa, la birou sau in alte spatii pe care doriti sa
le protejati. Aceasta va suna de fiecare data cand sistemul de alarma
este declansat de un senzor de miscare sau un contact magnetic.
Instalare si utilizare
Nota: Codul master care seteaza frecventa unica de comunicare intre
sirena si transmitator este setat din fabrica.
Pentru a utiliza sirena impreuna cu un sistem de alarma procedati in felul
urmator:
1. Conectati transmitatorul la iesirea de sirena din centrala de alarma.
2. Montati sirena intr-un loc convenabil si apoi conectati adaptorul de
alimentare.
3. Declansarea sirenei: aceasta poate fi declansata direct din
telecomanda sistemului de alarma apasand butonul de panica sau de un
detector de miscare/contact magnetic daca sistemul de alarma este
armat.
4. Oprirea sirenei: dezarmati sistemul de alarma. Sirena va mai suna
inca 5 secunde, dupa care se va opri.
Specificatii tehnice
ŸAlimentare: 12V (cu adaptorul de alimentare din pachet)
ŸIntensitate sonora: 110dB
ŸConsum: 350mA in alarma
ŸFrecventa sunet: 3.8KHz ± 10%
ŸDistanta intre transmitator si sirena: maxim 50m la interior
Pachetul contine:
Ÿsirena de interior
Ÿadaptor alimentare sirena
Ÿtransmitator alarma
Ÿmanual de utilizare
Manual de utilizare
Sirena de interior wireless
PNI A014

EN
Introduction
The PNI A014 indoor siren can be used with a burglar alarm system
installed in your home, office or any other space you want to protect. The
siren will sound every time the alarm system is activated by a motion
detector or magnetic door contact.
Installation and operation
Note: The master code that sets the communication frequency between
the siren and the transmitter is allready set by the factory.
To use the siren with a burglar alarm system follow the steps bellow:
1. Connect the transmitter to the siren output of the alarm main unit.
2. Mount the siren in a convenient place and then connect it to the power
adapter.
3. Alarm mode: the siren can be triggered by pressing the panic button on
the remote control of the alarm system or when the alarm system is
armed and a motion detector or magnetic contact is triggered.
4. To stop the siren from sounding you have to disarm the alarm system.
After disarming the siren will sound an extra 5 sec then it will stop.
Technical specification
ŸPower voltage: 12V (with power adapter)
ŸAcoustic power: 110dB
ŸPower demand: 350mA in alarm mode
ŸSound frequency: 3.8KHz ± 10%
ŸDistance between transmitter and siren: max 50m indoor
Package contents:
Ÿindoor siren
Ÿpower adapter
Ÿalarm transmitter
Ÿuser manual
User manual
Indoor wireless siren
PNI A014