Poly Rove B2 User manual

Pairing A Poly Rove Handset To A B2 Base
Objective
Pairing a Poly Rove handset to an active B2 Base unit.
Applies To
• Poly Rove B2 Base
• Poly Rove 30 Handset
• Poly Rove 40 Handset
Procedure
1. Press and hold the button at the top of the B2 Base until it starts blinking green
https://support.8x8.com/equipment-devices/phones/poly/Pairing_A_Poly_Rove_Handset_To_A_B2_Base
Updated: Fri, 14 Oct 2022 20:53:18 GMT
Powered by
1

2. On the handset you wish to pair, press the menu button
3. Navigate to Settings -> Connectivity -> Register -> Select first empty slot -> Enter Access/PIN Code (currently
'0000' for all Rove devices)
4. Press Ok and the handset should register
5. Repeat steps 2-3 until all handsets are registered
6. Press and hold the button at the top of the B2 Base until it STOPS blinking and is solid green
https://support.8x8.com/equipment-devices/phones/poly/Pairing_A_Poly_Rove_Handset_To_A_B2_Base
Updated: Fri, 14 Oct 2022 20:53:18 GMT
Powered by
2

7. To double check that the handset was registered you can press and immediately release the B2 Base button and that
will start paging all registered handsets
Additional Information
Known Poly limitations on Poly Rove B2:
• Maximum of 5 concurrent calls when G722 codec is used on all calls.
• Maximum of 4 concurrent calls when G729a codec is used on all calls.
• When G722 codec is enabled on the base, even if all calls negotiate to G711 codec, the maximum number of calls
is 9.
• SRTP cannot be enabled on this device in Admin Console. If this feature is required, please reach out to our
support team who can enable it.
• Poly does not yet support SIP Publishes on Rove devices, so no quality metrics will be available in ‘Analytics for
8x8 Work.
https://support.8x8.com/equipment-devices/phones/poly/Pairing_A_Poly_Rove_Handset_To_A_B2_Base
Updated: Fri, 14 Oct 2022 20:53:18 GMT
Powered by
3