Saxby Lighting 75145 Manual

• Flicker-freeforwholedimmingrange
• Stand-bypowerbelow0.5W
• Primarydimmingwithpush&DALIdimming
• Secondarydimmingwith1-10Vdimmer
• Canbedimmedviaapotentiometer
• Protectionagainstshortcircuit/overheat/overload
Instruction leaflet
40W LED Driver
75145/(ML40C-PDV1)
Features
• Operatingtemperature:-25oC-50oC
• Dimming:DALI,PUSH&1-10V
• Outputvoltage:700mA6~58VDC4.2-40W;
800mA6~50VDC4.8-40W;
 900mA6~45VDC5.4-40W;
950mA6~42VDC5.7-40W;
 1050mA6~38VDC6.3-40W;
 1200mA6~33VDC7.2-40W;
• Max.cablelengthinDALIsystem:300m
• DALIstandard:IEC62386-102,IEC62386-207
• Ratedvoltage:220-240VAC,50/60Hz
• Ratedcurrent:0.25A(max)
Electrical Specification
Connection
• Startwithsettingtheoutputcurrent.Thecurrentcanbeeasilyconfiguredbychoosing
thecorrectcombinationontheDIPswitches(seeFig.1)
• Dependingonchosendimmingpreference,connecttheluminairestothedriver
accordingtothewiringdiagramoverleaf(SeeFig.A,B,orC)
• Thisdrivercanalsobewiredinparallel.
• PleaseNote:-selecteddimmermustbewiredaccordingtomanufacturer’sinstruction.
Push Dimming ( see wiring diagram Fig. A)
1.SwitchON/OFFwithin120ms-1sectoswitchunitONandOFF.
2.Switchonce.Gradualdimmingrangewillinitiate>1sec.
3.Switchoncetopauseondesireddimmedlevel.
4.Switchonceagaintoinitiategradualdimmingrange>1secinreversedirection.
5.Repeatsteps3/4asnecessary.
1-10V Dimming ( see wiring diagram Fig. C)
• Thisdriversupportsanyactive1-10Vdimmer.
DALI Dimming ( see wiring diagram Fig. B)
• ThisdriverhasabuiltinDALIInterface.
www.saxbylighting.com
Saxby Lighting. BH23 3PE
Iss 1 09112017
Fig. 1

Connection/ Wiring Diagram
Fig. A: Push Dimming
Fig. C: 1-10V Dimming
Fig. B: DALI Dimming
The LED Driver is double insulated and must not
be earthed. If there are any incoming earth cables,
they must be joined together and well insulated with
good quality insulation tape. This is to ensure earth
continuity throughout your property.
Remove the cover on the LED driver using a small
electrical screwdriver and having correctly identified
the wiring from your existing light fitting, connect to
the connection block inside the LED driver.
1
2
See diagram below. To connect the
wiring to the connection block, depress
the button using a small electrical
screwdriver and insert wiring. release
button to secure.