Warnings
Please read these instructions carefully before commencing any work.
Check the pack and make sure you have all the parts listed.
All electronic parts fixed already, any intention of opening work-light or changing work-light design is prohibitive unless a
professional electrician.
Do not mix old and new batteries.
Do not mix batteries of different types.
Always insert the batteries with the correct polarity.
Always remove exhausted batteries from the product.
Do not use rechargeable batteries.
Children should not be permitted to use.
The battery should not be opened, destroyed or incinerate, since the may leak or rupture and release to the environment the
ingredients that they contain in the hermetically sealed container. Do not short circuit terminals, or over charge the battery,
forced over-discharge, throw to fire. Do not crush or puncture the battery, or immerse in liquids.
Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist. Check with
your local authority or retailer for recycling advice.
Thank you for purchasing this light fitting. Please read the instructions carefully before use to ensure safe and satisfactory
operation of this product. Please retain these instructions for future reference.
Installation
Sensor Setting
Existing fittings must be completely removed before installation of a new product.
Ensure that the screws and cable entry points are sealed to maintain the IP rating of the product.
This product must be installed into concrete or paving slab. It must not be installed into soil.
Follow the Installation Fig to install:
• Using base plate as a template, mark the fixing holes onto the mounting surface.
• Drill holes to the necessary size and depth.
• We recommend fitting this product with screws which are suitable for use on most surfaces, however alternative
fixings may be required.
• Push the plastic plugs into the mounting holes as shown.
• Locate the product in position and fit the screws to secure in place.
Mode 1: Press and hold the switch for 3 seconds to turn on, the product will stay on at 45Lm.
Mode 2: After mode 1, press the switch to change to mode 2. Product will stay on at 45LM and increase to 180LM
when motion is detected (This will stay at 180LM for 25 seconds then dim to 45LM and stay lit).
Mode 3: After mode 2, press the switch to change to mode 3. Product will be 400LM when motion is detected and
will turn off after 25 seconds.
Mode 4: Press and hold the switch for 3 seconds to turn it off.
Installation Fig
Battery Replacement
Refer the Installation Fig to set the sensor (please operate after dark):
Once desired setting of sensor has been set, your light is now ready for use.
OFF
＂
3
OFF
400
LUMEN
180
45
LUMEN
LUMEN
Press
Press
＂
3
45 LUMEN
Press and Hold
Press and Hold
3S
3S
OFFON
110
• Press and hold the switch for 3 seconds to turn it off.
• Separate the lamp head from the steel body easily and keep safe for refitting later.
• Unscrewing two screws with a screwdriver.
• Remove the old batteries and replace. Ensure the correct polarity is observed.
• Screwing two screws back into the original position.
• Refit back into the lamp head.
• Press and hold the switch for 3 seconds to turn on. Reset as wanted.
2
4
4
2
1
3
2X
3
21
1
2X
