teko Astra-515 ver.A User manual

Astra-515 ver. A
Optic-Electronic PIR Motion
Detector
(Volumetric Lens)
User Guide
Manufacturer:
ZAO NTC TEKO
420108 Kazan, Russia
Gafuri 71
[phone]
[email protected]
www.teko.biz
Made in Russia Rev. 515-av1_6_instr_en
1 FUNCTION
Detector is intended to detect unauthorized
access into enclosed protected area and
generate alarm notification by opening of
signaling relay contacts.
2 DETECTION ZONE
3 SPECIFICATION
Range of detectable
moving speed, m/sec .............from 0.3 up to 3.0
Power supply voltage, V.............from 8 up to 15
Current consumption, mA, max..................... 15
Overall dimensions, mm.................... 86×54×41
Operating Conditions
Temperature range, °С............... from 0 to + 50
Relative air humidity, % ......... up to 95 at + 35 °С
Withoutmoisture condensation
4 DELIVERY SET
Delivery set includes: bracket - 1 pcs., label –2
pcs.
5 MODES OF OPERATION
Plug
name
Jumper
position
High detectability
Normal
detectability
Sens
Indication OFF
Indication ON
Ind

6 INSTALLATION PLACE
1) Recommended installation height is 2.4-2.5 m.
2) Install detector on bearing walls and carri-
ers.
3) Alarm loop and power supply wires should
be located far from power cables.
To eliminate false alarm hazards
It is recommended to close all doors, air-vents,
switch off fans, air-conditioners and other
sources of intense air flows in the room during
protection period.
Not recommended installation locations
7 INSTALLATION PROCEDURE
1) Remove cover
2) Remove PCB
3) Select installation
method 4) or 5)
4)Installation on the
wall
5) Installation in the
corner using bracket
6) Insert PCB and
perform wiring (see
sec.8)
7) Perform TEST-pass (see sec.9)
8 WIRING
Perform wiring to detector`s terminals in
accordance with control panel operating manual.
RELAY –terminals for detector connection to
alarm loop;
+12V, GND –power supply terminals.
9 TEST-PASS
1) Remove jumper from Ind plug. Install jumper
on Sens plug.
2) Close detector.
3) Power detector ON. LED starts flash during
60 sec.
4) To detect sensitive zones carry out TEST-
pass in the secured zone
with the speed of 0,3 m/sec.
Stop upon detection
(indicator lights up for 2sec),
mark position, then make a
step back and continue
moving forward.
Repeat TEST-pass inversely.
10 WARRANTY
The operation warranty period is 5 years from
the date of operation start-up but no longer than
5 years 6 months from the date of manufactur-
ing subject to the requirements of Operating
Manual.