Victory 4x4 V200HMP Configuration guide

200 SERIES & LX 570
HATCH MOLLE PANEL
INSTALL INSTRUCTIONS
Please read the mounting instructions below carefully before attempting to install.
Be sure to check out the install video on the product page, if available.
Thank you for purchasing from JcrOroad! Checkout our website, www.victory4x4.com for other great o-road
products. Be sure to rate and review our product online. If you have any questions or are missing parts, please
don’t hesitate to call us at 269-459-8447!

INCLUDED HARDWARE
5x 5x
5/16” Flange Nut 5/16” x 1-1/4” Long
Carriage Bolt
5x
3/4” OD
Aluminium Spacer

INCLUDED PARTS
1x

DISASSEMBLY
1. Start by opening the rear hatch and popping o the plastic trim around
the top of the hatch. Be sure to start with the top middle piece with the
3rd brake light in it. Once the first peice is removed, be sure to un-hook the
light from the plastic. It is easiest to use a plastic pry tool or a flat head
screw driver to help pop out the clips.
2. Once the trim pieces are removed, you will need to take the largest of
them and modify it. It is easiest to set the piece on a flat surface or a
workbench when modifying it.

ASSEMBLY
3. Take the provided molle panel and lay it on top of the trim panel and
visually line it up in the middle and so it is centered, as shown below. Once
the panel is centered, take a sharp punch or a sharpie and mark the center
of the (5) diamond shaped mounting holes on the plastic to drill out.

ASSEMBLY
5. Aer your holes are drilled, install the (5) provided carriage bolts and
aluminum sapcers, as shown in the orientation below, and line them up
with the drilled holes on top of the plastic. Then thread the (5) provided
flange nuts onto the bolts on the back of the plastic. Once all (5) are
started, you can then fully tighten them down with a 1/2” socket and
wrench.
4. Take a step bit and drill your (5) marked holes out to 5/16” to accomodate
the provided carriage bolts.

ASSEMBLY
6. Once your panel is secure to your plastic hatch piece, you can then start
to re-assemble that back onto your vehicle with the rest of the trim pieces
that were removed. Be sure to clip the 3rd brake light back in before
clipping the hatch fully back into place.