Victory 4x4 UNI-RTTF Configuration guide

UNIVERSAL
ROOF RACK TENT
FAIRING
Thank you for purchasing from Victory 4x4! Checkout our website, victory4x4.com for other great o-road
products. Be sure to rate and review our product online. If you have any questions or are missing parts, please
don’t hesitate to call us at 269-459-8447!
INSTALL INSTRUCTIONS
Please read the mounting instructions below carefully before attempting to install.
Be sure to check out the install video on the product page, if available.

INCLUDED HARDWARE
6x 6x
5/16”-18-3/4”
Button Head 5/16”-18
U-Nut
6x 6x
5/16”-18 1” Long
Carriage Bolt
5/16”-18 Serr
Flange Nut
6x 6x
1/4”-20 3/8” Long
Stainless Stell Button Head
1/4”-20 Thread
T-Nut

INCLUDED PARTS
1x
3x
2x

INSTALLATION
1. Start with assembling the (3) fairing pieces using the provided carriage
bolts and 5/16” flange nuts as shown in the orientation below. You will
need to adjust the width according to your vehicle using the slots on the
smaller brackets. At any width adjustment less than 54”, the outer most
carriage bolts will need to be omitted on both sides. For 44” wide racks,
you will omit the side brackets entirely. Be sure to install the bolts in the
empty holes still to avoid wind noise.
2. Take the (3) smaller brackets and place the (6) provided clip nuts over the
holes in the orientation as shown below. Once the clip nuts are in place,
take the (3) brackets and loosely install them to the closest crossbar in
front of your tent using the provided T-nuts and 1/4” button head bolts, as
shown below.

INSTALLATION
3. Once your (3) brackets are loosely installed, you can then secure the fairing
previously assembled to them using the provided longer 5/16” button
heads into the clip nuts, as shown below. You may need to adjust the
distance in-between the brackets so all the holes line up to the fairing.

INSTALLATION
4. Once all of the hardware is started, go back and fully tighten down and
secure the brackets to the crossbar and make sure the rest of the hardware
is tight to finsih the install.