Wren Kitchens FI.PK.FIT.004 User manual

For Internal Use: FI.PK.FIT.004_50-WKIN00004_AppHousing_Rev5.indd
Page 1
FITTING GUIDE
Appliance
Housing
FI.PK.FIT.004
(H) x4 1 ¼” Screws
(B) x22
(J) x2 L Bracket Small
(K) x2 L Bracket Large
(R) x2 Dummy Fixing Clip
Step 2.
Screw up through the front rail into
your countertop to secure it in place,
then also through the back rail into
your wall. Screws for attaching
to the wall are not supplied as
these vary depending on your wall
material and construction. Ensure
appropriate xings for wall
construction are used.
(G) x2 ¾” Screws
Step 1.
(B) to secure each
of the L brackets LGE (K) to the
cabinets at either side.
Then screw up through into the
countertop as shown.
Sample Cabinet Shown
HEIGHT: 34 ½”


H
BB
K
Bottom Filler
Top Filler
Step 3.
Screw into any adjacent cabinets
using 1 ¼” screws (H) provided to
secure the cabinet. Screw at the top
and bottom of the left and right
sides of the cabinet. Place a cover
cap on the head to conceal it.
Screws for attaching to walls and countertop are not provided as these vary depending
-
tertop construction are used. Please refer to the specialist countertop supplier if these
are required for solid surface countertops.

For Internal Use: FI.PK.FIT.004_50-WKIN00004_AppHousing_Rev5.indd
Page 2
FITTING GUIDE
Appliance
Housing
Step 4.
Secure L bracket SML (J) onto the inside face of the Top

(B). Align

Step 6.
(Rii)
onto both end panels using
(B) each, as shown.
The centre hole is to be positioned


1
INSIDE FACE
from bottom
Front
Bottom
Filler
Top
Filler from sides
Sample Cabinet Shown
J
B
B
J
Step 5.
(J) to
(B) as shown.
1 from front
(Rii)
INSIDE FACE
 from sides
1
from top
(Ri) (Ri)
Step 7.
(Ri) onto the inside


2x ¾” screws (G).
(Ri)
G
  from side
 
1
from top
1