HunterDouglas SCG 64 User manual

REV 08 October`10
max 1000 mm
Install the roller blind. Level the side guiding chan-

channel against the bottom of the end cap. Mark the
drilling positions.
Type SCG 64
Fix the side guiding channel (with provided screws)
on the marked position.
Press the cover caps onto the drill holes.
Installation with screw Installation Instruction
Roller Blind
Side Channel Guiding
Installation in recess
         

side guiding channels.
-
side of the bracket. Fix the channel in this position
(with provided screws).
Divide the width between both outer drill holes into
equal sections (in accordance with possibilities).
Pay attention that the maximum distance of 1000
mm between two drill holes will not be exceeded.
Distance between drill holes

X = max.
1000 mm
click
X
REV 08 October`10
100 mm
Ø 5,5 mm
Ø 10 mm
100 mm
Ø5,5 mm Ø10 mm
!  
end cap. Mark the horizontal position of the screw
with X = 75 mm to the bottom of the end cap.
Fix the clip with provided screw. Snap the other
clips sidewise onto the side guiding channel.
Place the side guiding channel sidewise into the up-
per clip. Level the side guiding channel. Slide a clip
to the lower position. Level the bottom of the clip and
side guiding channel. Mark the hole.
Place the distance plate behind the bracket. Pay at-
tention that the printing should be the same as on
the bracket (L or R). Align the distance plate to the

Divide and mark the other clips with an equal dis-
tance (max 1000 mm). Remove the channel from
the clip. Fix the clips. Place the bottom rail into the
side guiding channel.
Place the side guiding channel above the clips.
Snap the channel into the clips. Fix the left side

Series 5-30, 5-40, 5-100 & 5-120 Arrangement of drill holes
Drill a hole (Ø 5,5 mm) in the groove of the side guid-
"
       #$$  % 
inner hole up to Ø 10 mm.
Drill a hole (Ø 5,5 mm) in the groove of the side
"
#$$&
side the hole diameter has to be 10 mm.
Loose the screw and remove the bottom end cap
'
Wall installation with cap
Side installation in recess
Installation with clip